1990 Dodge 150 on 2040-cars

Auto blog

Corvette Z06 and Viper TA square off at the strip

There are many long-standing grudge matches among automobiles: 911 vs GT-R, Mustang vs Camaro, Ferrari vs Lamborghini... but as far as high-end American metal goes, it doesn't get much more legendary than Viper vs 'Vette. So after Chevy released the new Corvette Z06, we knew it was only a matter of time before it would have to square off against the Viper TA. And what better place to pit these two parallel pillars of American performance than on the drag strip? Fortunately that's just what we have here. In one corner, the 2014 Dodge Viper TA, with its 8.4-liter V10 pumping out 640 horsepower and 600 pound-feet of torque. In the other, the 2015 Chevrolet Corvette Z06, the supercharger on its 6.2-liter V8 more than making up for the discrepancy in displacement and cylinder count to produce 650 hp and just as much torque. But numbers don't tell the whole story, so watch the video clip to see which reaches the end of the quarter-mile first. News Source: To the Floor via YouTubeTip: James Chevrolet Dodge Videos drag race chevy corvette z06 quarter mile drag strip srt viper ta

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

Marchionne says no offers are on the table for Fiat Chrysler

MONZA, Italy (Reuters) - Fiat Chrysler (FCA) has not received any offer for the company nor is the world's seventh-largest carmaker working on any "big deal", Chief Executive Sergio Marchionne said on Saturday. Speaking on the sidelines of the Italian Formula One Grand Prix, Marchionne said the focus remained on executing the company's business plan to 2018. Asked whether FCA had been approached by someone or whether there was an offer on the table, he simply said: "No." The company's share price jumped to record highs last month after reports of interest for the group or some of its brands from China. China's Great Wall Motor Co Ltd openly said it was interested in FCA, but had not held talks or signed a deal with executives at the Italian-American automaker. The stock move was also helped by expectations that the company might separate from some of its units. Marchionne reiterated on Saturday that FCA was working on a plan to "purify" its portfolio and that units, such as the components businesses, would be separated from the group. He hopes to complete that process by the end of 2018. "There are activities within the group that do not belong to a car manufacturer, for example the components businesses. The group needs to be cleared of those things," he told journalists. Asked whether an announcement could come this year, Marchionne said it was up to the board to decide and that it would next meet at the end of September. He said the time was not right for a spin-off of luxury brand Maserati and premium Alfa Romeo and the two brands needed to become self-sustainable entities first and "have the muscle to stand on their feet, make sufficient cash". "The way we see it now, it's almost impossible, if not impossible, to see a spin-off of Alfa Romeo/Maserati, these are two entities that are immature and in a development phase," he said. "It's the wrong moment, we are not in a condition to do it." He said the concept of separating the two brands from FCA's mass market business made sense and did not rule out this happening in future, but not under his tenure, which lasts until April 2019. "If there is an opportunity in future, it would certainly happen after I'm gone. It won't happen while Marchionne is around," he said.