2014 Chrysler Town & Country Touring L on 2040-cars
Ooltewah, Tennessee, United States
Transmission:Automatic
Vehicle Title:Clean
Engine:3.6L Flexible V6
VIN (Vehicle Identification Number): 2C4RC1CG1ER133828
Mileage: 153000
Trim: TOURING L
Number of Cylinders: 6
Model: Town & Country
Exterior Color: Blue
Make: Chrysler
Drive Type: FWD
Chrysler Town & Country for Sale
- 2016 chrysler town & country touring(US $12,550.00)
- 2005 chrysler town & country limited(US $20,000.00)
- 2009 chrysler town & country(US $500.00)
- 2006 chrysler town & country(US $500.00)
- 2016 chrysler town & country(US $13,500.00)
- 2016 chrysler town & country wheelchair accessible handicap ramp van rear entry(US $200.00)
Auto Services in Tennessee
Wheeler`s Automotive ★★★★★
Wayne`s Radiator Service ★★★★★
Watson Auto Sales West ★★★★★
Universal Kia Franklin ★★★★★
The Automotive Solution ★★★★★
Taylor Tom Chevrolet-Pontiac-Oldsmobile Truck-Chrysler Plymouth-Dodge-Jeep ★★★★★
Auto blog
Chrysler's Hurricane engine detailed ahead of 2016 launch
Fri, 20 Sep 2013We've been hearing distant rumblings about Chrysler's new Hurricane engine for some time now, but details have been hard to come by. Now, Automotive News is adding some specifics to the scuttlebutt, citing Chrysler documents. According to the industry publication, the Hurricane will blow onto the scene in 2016, but it's not an all-new engine. Rather, it will be rooted in the company's existing 2.0-liter four-cylinder Tigershark powerplant (shown above), albeit with "many new technologies to achieve excellent fuel economy."
It's not clear what sort of technologies Chrysler is referring to, but the Hurricane is expected to continue to use an aluminum block, and the finished product is expected to generate even better figures than the existing 2.0-liter's 160 horsepower and 148 pound-feet of torque (as found in the Dodge Dart). Automotive News notes that the updated 2.4-liter Tigershark debuting in the entry-level 2014 Jeep Cherokee has its basis in the 2.0-liter lump, but unlike the smaller engine, it's been fitted with MultiAir2 electrohydraulic variable valve timing to realize 184 hp and 171 lb-ft and greater efficiency.
Perhaps the Hurricane will incorporate the latter in its bag of tricks? Either way, we're hoping for a more generous torque curve than the what's in the current 2.0-liter Tigershark, which is something of a slug in the Dart - even for a base economy compact.
Chrysler says its 8-speed transmissions will save 700 million gallons
Thu, Jun 19 2014Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.
Chrysler releases Born Maker ad campaign for 2015 200 [w/video]
Fri, 06 Jun 2014
"The 200 sets the benchmark, for us, on how we plan to develop cars going forward." - Marissa Hunter
Is the 2015 Chrysler 200 the most important new product for Fiat Chrysler Automobiles? While it is certainly debatable, we'd be strongly inclined to say "yes." As the first competent midsize sedan that Chrysler has released in the better part of two decades, the new 200 is absolutely crucial to achieving the brand's goal of becoming FCA's "mainstream" manufacturer.