2004 Chrysler Sebring Base Sedan 4-door 2.4l on 2040-cars

Auto blog

Chrysler killing off the 200 Convertible, Dodge Avenger

When Chrysler rolled out the first-generation 200 to replace the Sebring range in 2010, it included replacements for both the sedan and the convertible. The Sebring Coupe, however, was left out of the mix. And now that the second-generation Chrysler 200 is descending upon us, Auburn Hills is paring things down even further. But this time, it's the convertible that reportedly isn't making the cut. Shame, too, since the rendering above shows what could have been quite an attractive droptop.
As our compatriots at Edmunds point out, sales of the convertible model accounted for less than five percent of overall Chrysler 200 sales, and at those numbers, the considerable cost of engineering a new drop-top couldn't be justified. With the Toyota Camry Solara and Volkswagen Eos also gone from the market (well, the VW isn't gone quite yet), the discontinuation of the Chrysler 200 Convertible leaves the affordable convertible segment largely to the sportier likes of the Ford Mustang and Chevy Camaro and smaller European offerings like the Mini Cooper and VW Beetle.
The Chrysler 200 Convertible isn't the only derivative being left behind with the new model: so too is the Dodge Avenger. That will leave a glaring hole in the Dodge lineup, with nothing to bridge the gap between the compact Dart and the larger Charger. Whether the Dodge brand has any plans to replace the Avenger with another model, not to be based on the 200, remains to be seen.

Chrysler 200 prototype spied for first time with new body

Chrysler is deep into testing for its next-generation 200 sedan, a new model that is utterly essential to the brand's continued health. The next iteration is tasked with wiping away anything reminiscent of the Sebring, which the current 200 is still based on. According to our spy, this is one of the first of the new 200s to wear a production body rather than the Alfa Romeo Giulietta-based mules that are thick on the ground in Auburn Hills.
Immediately apparent is that the new 200 ditches the awkwardly styled C-pillar that's typified four-door 200 sedans (and Sebrings before them) for years. The new, sleeker roofline is almost more of a four-door coupe than a traditional sedan, which hints that this new car will try to be more fashion-forward than its predecessor. The rear deck is set off by a sporty decklid spoiler, while a set of staggered rectangular exhaust pipes poke out of the bumper.
The front end appears sleeker, and we'd be lying if we didn't spy a bit of Dart through the camouflage, particularly with the headlights. A large, gaping lower air intake is visible, although our spy seems to think it'll shrink before production models debut. Whatever the new 200 ends up looking like, we expect to see a lot more of its styling from Chrysler in the coming years.

10 automakers shack up in Detroit hotel to talk Takata airbags

Since Takata has decided not to take the lead concerning potential issues with its airbag inflators, the automakers have. Perhaps that's unsurprising, since it's the automakers, not Takata, that will take a beating on the dealership floor if consumers decide its models are a health hazards. The Detroit News reports that Toyota, Honda, General Motors, Ford, Chrysler, Mazda, BMW, Nissan, Mitsubishi and Subaru met in a hotel conference room near the Detroit Metropolitan Airport last week to sort out a way to understand the technical issues involved. So far, faulty airbag inflators have been ruled the cause of five deaths and 50 injuries around the world, but neither Takata nor investigators understands exactly why the inflators are malfunctioning. The National Highway Traffic Safety Administration recently asked Takata to issue a national recall, Takata declined, citing a minuscule failure rate and the fact that it's still investigating the issue. Toyota and Honda then made an industry-wide appeal for "a coordinated, comprehensive testing program" that would pinpoint the problem inflators and get them replaced, and that's what the Detroit meeting was about. Numerous issues, however, will make this a long row to hoe: simply getting the parts to replace the nearly 20 million inflators in cars recalled around the world so far - even working with other suppliers - will take a years, but more importantly, no one knows if the replacement inflators currently being installed will suffer the same issue. Answers will hopefully come quickly with Takata, the ten automakers and NHTSA all independently investigating the problem.