2000 Chrysler Prowler on 2040-cars

Auto blog

Mopar celebrates 50 years of the 426 Hemi

Think of Chrysler performance and the names Mopar and Hemi are bound to come to mind. Chrysler and its Mopar performance parts division first introduced the original Hemi (so named for its hemispherical combustion chambers) back in 1951, celebrating its 60th anniversary in 2011. But it was thirteen years later - 50 years ago - that the Pentastar automaker rolled out the most iconic Hemi of them all: the Gen II 426.
The massive 7.0-liter V8 engine instantly became a muscle car icon and went on to become a favorite of racecar constructors. Two competition versions of the Gen II 426 Hemi were made: one for the track and one for the drag strip, and both went on to illustrious strings of victories. The race engine first debuted at the 1964 Daytona 500 where it powered Richard Petty's Plymouth to the checkered flag and on to the NASCAR championship.
Meanwhile on the drag strip, the Gen II 426 Race Hemi propelled Don Garlits past 200 miles per hour and down the quarter-mile in 7.78 seconds. Changes in NASCAR regulations meant that Chrysler devoted the engine to NHRA drag racing, and to this day the Gen II 426 Race Hemi is still used in Funny Car and Top Fuel dragsters.

US expands probe into ZF-TRW airbag failure-to-deploy to 12.3 million vehicles

DETROIT — U.S. auto safety regulators have expanded an investigation into malfunctioning airbag controls to include 12.3 million vehicles because the bags may not inflate in a crash. The problem could be responsible for as many as eight deaths. Vehicles made by Toyota, Honda, Kia, Hyundai, Mitsubishi and Fiat Chrysler from the 2010 through 2019 model years are included in the probe, which was revealed Tuesday in documents posted by the National Highway Traffic Safety Administration. It involves airbag control units made by ZF-TRW that were installed in the vehicles. The control units can fail in a crash, possibly because of unwanted electrical signals produced by the crash itself that can disable an air bag control circuit housed in the passenger compartment, according to NHTSA documents. The electrical signals can damage the control circuit, the documents say. ZF, a German auto parts maker which acquired TRW Automotive in 2015, said in a statement that it's committed to safety and is cooperating with NHTSA and automakers in the investigation. The case is another in a long list of problems with auto industry airbags, including faulty and potentially deadly Takata airbag inflators. At least 24 people have been killed worldwide and more than 200 injured by the inflators, which can explode with too much force and hurl dangerous shrapnel into the passenger cabin. The inflators touched off the largest series of automotive recalls in U.S. history involving with as many as 70 million inflators to be recalled by the end of next year. About 100 million inflators are to be recalled worldwide. On April 19, NHTSA upgraded the ZF-TRW probe from a preliminary evaluation to an engineering analysis, which is a step closer toward seeking recalls. So far, only Hyundai and Kia and Fiat Chrysler have issued recalls in the case. Four deaths that may have been caused by the problem were reported in Hyundai-Kia vehicles and three in Fiat Chrysler automobiles. NHTSA opened an investigation in March of 2017 involving the TRW parts in Hyundais and Kias. The upgrade came after investigators found two recent serious crashes involving 2018 and 2019 Toyota Corollas in which the airbags did not inflate. One person was killed. Jason Levine, executive director of the Center for Auto Safety, a nonprofit consumer group, said the ZF-TRW case shows the auto industry thus far has learned very little from Takata.

Jeep hiring 1,000 part-time workers in Toledo on Wrangler, Cherokee demand

The new Jeep Cherokee has been quite a success for Chrysler, but its factory workers are getting tired. The automaker has agreed to hire up to 1,000 part-time, temporary employees at its Toledo Assembly Complex where the CUV and Wrangler are built. It will allow the company to keep Jeep production moving, while giving laborers a break.
According to plant manager Chuck Padden in the Toledo Blade, full-time workers are regularly taking on 60 hours a week, and it's beginning to wear on them. "To get them more time off is important to us, to make sure they're refreshed, and can work safely," said Padden.
Chrysler has already hired 380 temporary, part-time workers for the plant, and 50 have been converted to full-time employees. The company is in the process of interviewing the rest of the new hires now and plans to have all 1,000 in place by the summer. They will work between 10 and 30 hours a week mostly on weekends for $15.78 per hour with limited benefits. The temporary positions will last "as long as demand continues for the Jeep Wrangler and the Jeep Cherokee," said Jodi Tinson, Chrysler spokesperson for manufacturing and labor communications, to Autoblog in an email.