2014 Chrysler 300c Base on 2040-cars

Auto blog

Dodge Challenger spied exercising supercharged Hellcat Hemi V8

One of the prime complaints against the Dodge Challenger is that, even in SRT8 guise, its 470 horsepower is responsible for hauling over 4,200 pounds of vehicle. For comparison, the 420 hp in the Ford Mustang GT only has to deal with 3,618 lbs. Things only get worse from there, as the higher-performance variants of both the Mustang and the Chevrolet Camaro are far more powerful than an SRT8 without adding on much heft.
So what is Chrysler to do? The correct answer is add a whole lot more grunt to its hefty two-door and even the odds. That's where the all-new Hellcat engine comes into play. We reported on this engine in May, and suggested that the Hellcat, a supercharged powerplant based on a 6.4-liter V8, would easily generate 500 to 570 hp and could likely arrive boasting more than 600 ponies.
Chrysler's ace in its sleeve has now been spied testing, with a number of Hellcat-equipped Challengers running the potent new engine both in more urbanized areas and under the sun of Death Valley. The hoods on these testers have been raised to accommodate the engine, and that camouflage over the fascias of these prototypes is there to hide a larger air intake. We also note what appears to be a new split grille under wraps. As for power output, our spies are now suggesting a Viper-equalling 640 hp from the Hellcat-equipped cars.

2015 Chrysler 200 caught looking good after leaking out

We can't yet share all the details on the 2015 Chrysler 200 sedan, but we can direct your attention to the image above, which was published by the boys at Jalopnik after Chrysler reportedly let it out by accident. As you can see, the new 200 will be a nicely styled piece of machinery.
According to leaked documentation, the 2015 Chrysler 200 will come with the buyer's choice of a 2.4-liter Tiger Shark four-cylinder engine with 184 horsepower and 173 pound-feet of torque or a 3.6-liter Pentastar V6 boasting 295 horses and 262 lb-ft. Those ponies will be routed through a nine-speed automatic with a rotary gear selector, sending power to the front wheels. Alternatively, a high-tech all-wheel-drive system will be available that can electronically disconnect the rear axle, saving fuel.
Speaking of fuel efficiency, the 2015 200 will be able to achieve up to 35 miles per gallon on the highway, which is an impressive figure for this class. An on-sale date has yet to be announced, but the next 200 will start at $21,700 (plus $995 for destination) when it does finally hit dealerships.

Labor Day: A look back at the largest UAW strikes in history

American made is almost an anachronism now, but good manufacturing jobs drove America's post-war economic golden age. Fifty years ago, if you held a job on a line, you were most likely a member of a union. And no union was more powerful than the United Auto Workers. Before the slow decline in membership started in the 1970s, the UAW had over 1.5 million members and represented workers from the insurance industry to aerospace and defense. The UAW isn't the powerhouse it once was. Today, just fewer than 400,000 workers hold membership in the UAW. Unions are sometimes blamed for the decline of American manufacturing, as companies have spent the last 30 years outsourcing their needs to countries with cheap labor and fewer requirements for the health and safety of their workers. Unions formed out of a desire to protect workers from dangerous conditions and abject poverty once their physical abilities were used up on the line; woes that manufacturers now outsource to poorer countries, along with the jobs. Striking was the workers' way of demanding humane treatment and a seat at the table with management. Most strikes are and were local affairs, affecting one or two plants and lasting a few days. But some strikes took thousands of workers off the line for months. Some were large enough to change the landscape of America. 1. 1936-1937 Flint Sit-Down Strike In 1936, just a year after the UAW formed and the same year they held their first convention, the union moved to organize workers within a major manufacturer. For extra oomph, they went after the largest in the world – General Motors. UAW Local 174 president Walter Reuther focused on two huge production facilities – one in Flint and one in Cleveland, where GM made all the parts for Buick, Pontiac, Oldsmobile and Chevrolet. Conditions in these plants were hellish. Workers weren't allowed bathroom breaks and often soiled themselves while standing at their stations. Workers were pushed to the limit on 12-14 hour shifts, six days a week. The production speed was nearly impossibly fast and debilitating injuries were common. In July 1936, temperatures inside the Flint plants reached over 100 degrees, yet managers refused to slow the line. Heat exhaustion killed hundreds of workers. Their families could expect no compensation for their deaths. When two brothers were fired in Cleveland when management discovered they were part of the union, a wildcat strike broke out.