2007 Chevy Uplander Cargo Van Cargo Partition Shelving Texas Direct Auto on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Recharge Wrap-up: BYD unveils 60-ft electric bus, Honda sticking with hybrids in Europe

BYD has debuted a 60-foot electric bus at the American Public Transportation Association Expo in Houston, TX. The Lancaster bus, as it is called, has a 120-passenger capacity and can drive over 170 miles on a single charge. The articulated bus features low floors and no steps, thanks to in-wheel hub motors. BYD also displayed a 40-foot electric bus that drove the 1,500 miles to the show under its own power (recharging along the way, of course). Read more in the press release below. Honda says it will continue to sell hybrids in Europe, despite the fact that it has stopped selling the CR-Z and Insight due to slow sales. "Our focus at the moment is on our 1.6-liter diesel but we haven't forgotten about hybrid technology," says Honda Europe's Philip Ross. Honda will sell the next-generation Fit (badged as the Jazz) in Europe when it launches next summer, and will sell the next-gen hybrid version beginning in 2016. Honda sold 4,500 of the Jazz hybrid in Europe last year. Read more at Automotive News. XL Hybrids is selling its XL3 Hybrid Electric Drive System in California. The news comes after the California Air Resources Board issued an executive order allowing the aftermarket hybrid conversion for 2012-2014 Chevrolet Express and GMC Savana vans. The XL3 Hybrid regenerative braking conversion increases real-world mpg by about 25 percent. Read more in the press release below. NRG eVgo has finished installing 60 charging stations at the Sony Pictures Entertainment studio lot and offices in Culver City, California. The Level 2 chargers, which will be managed by NRG eVgo, allow employees to charge their EVs during the workday. An average of 90 EVs and PHEVs park at the studio headquarters every day, thanks in part to Sony Pictures' Alternative Vehicles Incentive program for its employees. Learn more in the press release below. Pennsylvania's Public Utility Commission will allow operators of EV charging stations to set prices based on kilowatt hour usage. This change ensures that drivers pay for the actual energy they use, rather than the time they spend charging, since different cars can charge at different speeds. Car Charging Group has already begun using the per-kWh fee structure at its charging stations throughout the state. Other states that allow kWh pricing are California, Colorado, Florida, Hawaii, Illinois, Maryland, Minnesota, New York, Oregon, Virginia and Washington. Read more in the press release below.

Even if GM does close all 5 of those plants, it'll still have too many

DETROIT — General Motors' monumental announcement on Monday that it will close three car assembly plants and two powertrain plants in North America and slash its workforce will only partially close the gap between capacity and demand for the automaker's sedans, according to a Reuters analysis of industry production and capacity data. Sales of traditional passenger cars in North America have been declining for the past six years and are still withering. After GM ends production next year at factories in Michigan, Ohio and Ontario, it will still have four U.S. passenger-car plants — all operating at less than 50 percent of rated capacity, according to figures supplied by LMC Automotive. In comparison, Detroit-based rivals Ford and Fiat Chrysler Automobiles will have one car plant each in North America after 2019. The Detroit Three are facing rapidly dwindling demand for traditional passenger cars from U.S. consumers, many of whom have shifted to crossovers and trucks. Passenger cars accounted for 48 percent of retail light-vehicle sales in the United States in 2014, according to market researchers at J.D. Power and Associates. This year, sedans will account for less than a third of light vehicle sales. That shift in turn has left most North American car plants operating far below their rated capacities, while many SUV and truck plants are running on overtime. The collapse in passenger-car demand is a challenge for nearly all automakers in the United States, including Japan's Toyota and Honda, which have the top-selling models in the compact and midsize car segments. Toyota executives said last month they are evaluating the company's U.S. model lineup. But Toyota also plans to build compact Corolla sedans at a new $1.6 billion factory it is building in Alabama with partner Mazda. The obstacles facing GM in its plans to close more auto factories became apparent on Tuesday as U.S. President Donald Trump threatened to block payment of government electric vehicle subsidies to GM. While it is not certain that Trump unilaterally has the power to do that, he made it clear he intends to use his office to pressure the company to keep open a small car plant in Ohio that GM says will stop building vehicles in March.