2006 Chevrolet Trailblazer 4x4 on 2040-cars

Auto blog

GM opens official investigation into C8 Corvette transmission leaks

In March 2020, a month after Chevrolet began customer deliveries of the 2020 C8 Corvette, a GM dealer technician created a Reddit thread about a leaking gearbox in a Corvette with 32 miles. That car hadn't even been sold yet. Since then, as a search of "C8 Corvette transmission leak" shows, it's been tales of woe for some owners. Something in the Tremec TR-9080 transaxle in the back of the mid-engined Corvette doesn't work as it should, the fault able to cause codes that the transmission needs service, or that the driver needs to shift to park. In some cases, the battery would die because of follow-on issues after the initial transmission code, that code preventing the car from powering down. As Autoevolution reports, GM filed paperwork with the National Highway Traffic Safety Administration in August to look into what's going on. Between forum threads and GM's investigation document, there are several issues mentioned. The most common appears to be the dual-clutch transmission leaking fluid due to gasket failures like the one suffered by one owner at 858 miles, and another for an owner currently enduring a second leaking transmission. The Midengined Corvette Forum reported that Chevy engineers redesigned the TR-9080 pan, fitting Corvettes with the new unit at some point in the 2021 model year. The original pan was stamped steel unit affixed to the engine with two studs and 13 bolts, plus "reinforcement plates." The updated pan is said to be a cast aluminum unit affixed with two studs and 17 bolts, omits the reinforcement plates, and gets a new machined new groove around its edge to seat the gasket seal. The GM paperwork now at the NHTSA mentions a P1789 code, and says one reason for it could be "debris on the park position sensor magnet causing an incorrect position reading to the TCM." This might be caused by another issue mentioned in forums, which is clogged transmission filters. GM gives instructions for returning transmission filters to the company, and a poster on one forum said the Corvette tech at the dealer where he bought his Corvette told him the automaker "requires every used transmission filter to be returned to GM."  Whatever's going on, the problems haven't stopped, and they go beyond the P1789 code. Over the weekend, a 2022 Corvette owner posted on Corvette Forums that he got a check engine light on his car after just 850 miles.

Man spent $75 on a truck that lasted 38 years

Absurd as it is, some buyers today are worried about getting their car to last throughout the term of their seven-year car loan. Minnesota resident Bob Sportel has the opposite issue: his Chevrolet truck seemingly won't die. Sportel needed a cheap ride to get to work when he took a job at a farmer's co-op 38 years ago, so he bought a rusty 1957 Chevy pickup for $75 from a farmer; at the time, the 20-year-old truck was almost as old as Bob was. After nearly four decades of daily driving and an estimated 300,000 miles, Sportel is still driving the truck today. Bolts secure a fender, Bondo secures the lights, what looks like a whole roll of duct tape keeps him sitting on the bench seat instead of in it. For a 58-year-old pickup that's never seen a garage or a new coat of paint – but did get its oil changed four times a year – that's not bad; Sportel thinks his repair bill hasn't got above $1,000 for the entire time he's owned the truck. He still has no plans to get rid of it, saying, "It just becomes a part of you." You can watch his story in the video above. News Source: KARE11.com Chevrolet Truck Classics Videos

UAW to vote on strike at Kentucky Corvette plant

The current wait time for a new Chevrolet Corvette Stingray is well, not short. With word of a strike at the Bowling Green, KY factory responsible for seventh-generation sports car, though, that wait time could end up growing substantially.
Now, a strike is still a ways off. UAW Local 2164, which represents the 800 workers responsible for screwing the Corvette together, is set to vote on authorizing a strike today, but even if the employees give the action a go, it's far from a sure thing. According to The Tennessean, both regional and national union officials would need to put their stamp of approval on strike action.
"The membership has to vote to strike, but it's just a step in the process," said Gary Casteel, the UAW's Region 8 director and one of the people that would need to authorize a strike action. Casteel told The Tennessean, "It's purely a local situation, though. They are having some issues with the local management."