1996 Chevrolet Tahoe Lt Sport Utility 4-door 5.7l on 2040-cars

Auto blog

Sinkhole Opens Up In National Corvette Museum, Swallows Eight Cars

More cars are being moved inside the National Corvette Museum in Bowling Green, Ky. to avoid falling down the same sinkhole that swallowed eight classic sports cars early this morning, Autoblog reported. Museum officials said the hole was discovered when motion sensors activated around 5:45 a.m. The rescue mission can be viewed on the museum's live feed cameras, which weren't working after the sinkhole emerged. A 1993 ZR-1 Spyder and a 2009 ZR1 "Blue Devil," both on loan from General Motors, were among the cars that fell into the sinkhole. The museum owned the other affected Corvettes, which included a 1963 Corvette, a 1984 PPG Pace Car and the 1 millionth Corvette ever produced. The state of the cars at the bottom of the hole isn't known, but trial lawyer and sinkhole expert Ted Corless said the cars may be a total loss for the museum and GM. "Most states, including Kentucky, exclude damage caused by sinkhole activity," he said. "There will be, in all likelihood, a claim made, but a lot of policies would specifically exclude these kinds of damages." Corless has 15 years experience dealing with sinkholes. He said that typically neither the building, nor the cars themselves are protected under their insurance policies. "I would have to say, more likely then not, they're going to have an uninsured loss measured in the hundreds of thousands of dollars." The museum is closed Wednesday while a structural engineer assesses the damage. Related Gallery 2014 Chevrolet Corvette Stingray Test Drive View 9 Photos Related Gallery 2014 Chevrolet Corvette Stingray Test Drive View 9 Photos Weird Car News Chevrolet GM corvette

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM announces net 220 job increase as Trump visits Michigan

GM announced today that about 900 jobs would be added (or, importantly, retained) ahead of President Trump's arrival in Michigan, where he is expected to discuss his plan to roll back fuel economy standards. The timing of the announcement is almost certainly not coincidental, as appending it to a Trump visit gives it a higher profile and dovetails with the President's jobs agenda. It's less likely the decision itself was made for those reasons, but the free PR boost is a nice bonus. As for those 900 jobs themselves, they aren't all new jobs. The only net gain is approximately 220 jobs at the Romulus Powertrain Plant, which produces the 10-speed automatic transmission that's proliferating through the company's lineup. The 180 jobs at Flint Assembly and 500 jobs at Lansing Delta Township are retained jobs – that is to say, spots the company found for workers who would otherwise have been laid off. By the way, the Flint jobs will help with production of heavy-duty pickups, and the Lansing jobs are to produce the Chevrolet Traverse and Buick Enclave. Finding jobs for manufacturing workers in the auto sector, whether new or retained, is admirable. No matter how GM couches it, the company has created or retained a total of 7,000 jobs this year, and its total reinvestment in US production is around $1 billion. But these decisions are business ones, not political ones – timing the announcements to make them seem inspired by economic policy, or the political situation, is simply smart PR. Related Video: Image Credit: Bill Pugliano/Getty Images Celebrities Government/Legal Buick Cadillac Chevrolet GMC