2007 Chevrolet Suburban Lt on 2040-cars

Auto blog

Anti-purist 1963 Ferrari GTE sports hot rod Chevy V8

I remember reading a story around the time Fast and Furious: Tokyo Drift came out. It focused on one of the star cars of that film, a 1967 Ford Mustang fastback that started the film as a shell, and in a pinch, was transformed into a modified masterpiece, complete with the RB26DETT engine from a Nissan Skyline GT-R (which started the film under the hood of an S15 Silvia). There was a genuine (and in our minds, absurd) fear in the article that taking a piece of classic American iron and fitting a twin-turbocharged JDM engine would result in some awful trend in the classic car community. If you thought a GT-R-powered classic Mustang was sacrilege, though, this car will probably make you vomit. For the rest of us, it's a neat piece of engineering. Shown above is a 1963 Ferrari 250 GTE, and yes, that's a 302-cubic-inch, small-block Chevrolet V8 under the hood. On top of that, it uses the six-speed manual transmission from a Viper, a nine-inch Ford rear end, and Mitsubishi-sourced paint. So yeah, it's a FrankenFerrari. Check out Road Heads' interview with this custom GTE's owner, which is followed by a brief test drive. And of course, head into Comments afterwards, and let us know what you think. Is this Yankee-powered 250 GTE blasphemous or badass?

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

The Chevrolet Bolt is headed to China as a Buick SUV

When spy photos of what appeared to be Chevrolet Bolt EV with some minor front- and rear-end updates circulated last week, Autoblog surmised that GM was working on some sort of Bolt-based vehicle — potentially a crossover — to be sold in China as a Buick. We may just have corroboration for that theory. On Thursday, Motor1.com spotted a story published earlier this week on the Chinese site Auto Home which claims that GM has applied to sell an all-electric SUV under the Velite 7 nameplate in China.  There's little differentiating the Velite 7's exterior from the Bolt EV's, apart from bumpers, badges, and a little extra ground clearance. Up front, the bowtie is replaced by a round Buick badge, and the bumper picks up an almost Prius-like appearance thanks to contrasting vertical elements and a thin grille bleeding into the head lights to give it a full-width appearance. Chevy Bolt-based prototype View 16 Photos If the Chinese report is accurate, there is one significant difference under the skin. Per the application, the Buick crossover variant is to be powered by a 174-horsepower electric powertrain. That's down 26 horsepower from the Bolt EV's powertrain, and we can't help but think that a lifted Buick variant might just need every pony it can get.  The needs of the Chinese market are unique, and we're certain GM knows what it's doing if these figures are accurate. We have no reason to believe Buick plans to sell the Velite 7 EV here in the States, though we expect an updated Chevy Bolt eventually, and we wouldn't be surprised if Buick brings something along shortly to fill the void left by the departure of the Regal sedan and its variants.  Related Video: