2004 Chevy 2500 Xcab Ls With Leather...duramax Diesel...2 Wheel Drive...like New on 2040-cars

Auto blog

C7 Corvette turbo with 1,000 horsepower promised from Hennessey

If you can't wait for the next-generation Chevrolet Corvette ZR1, Hennessey says they will have you covered. The Texas-based company has announced it will offer a spate of upgrades for the 2014 Corvette ranging from a range of bolt-on options all the way up to a 1,000-horsepower, twin-turbo system. Buyers can start with a cold air intake, cat-back exhaust or stainless steel long-tube headers, but Hennessey says it will also offer up three stages of forced induction mayhem should those bits and baubles not provide enough thrust.
Those choices start with a supercharger system good for up to 700 hp, though Hennessey will gladly ditch the blower in favor of two turbos. Doing so will spin the crank to the tune of 800 horsepower all the way up to a certifiably ludicrous 1,000 ponies. There's no word on how much these tricks will cost you - or when they will be available, as we're guessing they haven't gotten their hands on the car yet - but you can head over to the Hennessey site to drop them a line if you're curious.

GM recalling 426,000 sedans over faulty transmission shift cable

General Motors is recalling some 426,240 sedans that may have a faulty transmission shift cable, according to a National Highway Traffic Safety Administration report this morning. The recall concerns a fault within four-speed automatic transmissions equipped on 2007-2010 Saturn Aura models, and 2008-2010 Chevrolet Malibu and Pontiac G6 models.
The report specifies that tabs on the transmission shift cable may fracture and separate. Such a fault could cause a discrepancy between the actual position of the transmission and the apparent position of the shift lever.
GM is currently working to notify owners of the vehicles in question, and dealers will check and replace shift cables free of charge. Scroll down to read the complete NHTSA report.

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.