1981 Chevrolet K-5 Blazer 4x4 V8 4 Speed Manual. No Reserve!!!!!! on 2040-cars

Auto blog

GM re-recalls 11k SUVs

General Motors is recalling a bunch of previously recalled SUVs because, well, they still aren't quite fixed. The latest repairs are necessary on 10,974 SUVs in North America, including 9,932 in only the US. Affected models include the 2006-2007 Buick Rainier, Chevrolet Trailblazer, and GMC Envoy; plus the 2006 Trailblazer EXT and Envoy XL. While not listed by NHTSA, a statement by GM to Autoblog says the 2006-2007 Saab 9-7X and Isuzu Ascender are also affected. In these SUVs, it's possible that liquid could get into the driver's door master power window switch module and cause a short circuit. This could potentially lead to a fire, and owners are urged to park the vehicles outside until repaired. GM has been trying to fix this issue for years. It started as an investigation into fires, and that led to a recall for about 250,000 vehicles in cold-weather states. A nationwide campaign came in 2013 for 193,000 of them in the US. Last year, the automaker decided to replace the whole module as a repair. However in a recent investigation of these recalls, GM discovered that this latest group of SUVs never received the new part. According to documents submitted to NHTSA (as a PDF), "Some dealers incorrectly used the labor code associated with module replacement when, instead of replacing the module, they only added a protective coating to the module." To fix things this time, the models finally get the correct component. Related Video: GM Statement General Motors is recalling 9,932 older midsize SUVs in the U.S. because they were mistakenly excluded from an earlier recall. Certain 2006 Chevrolet TrailBlazer EXT and GMC Envoy XL, and 2006-2007 TrailBlazer, Envoy, Buick Rainier, Saab 9-7X and Isuzu Ascender vehicles may continue to have a condition in which the printed circuit board inside the driver's door may corrode and short if exposed to certain fluids such as melted snow containing road salt. GM is aware of four fires but no crashes, injuries or fatalities associated with the expanded recall. The total number of vehicles being recalled, including Canada, Mexico and exports is 10.974. Customers are urged to park these vehicles outside until repairs have been made. GM reported this recall to the NHTSA on September 23.

Camaro spy shots show subtly different grille, front fascia

It looks like there some changes in store for the Chevrolet Camaro - the only thing is that we just don't know what Chevy has up its sleeve. Looking at these spy shots, we'd initially be inclined to think that there is just a minor facelift or a new special edition, but upon closer inspection, there are a few oddities about this car that definitely have us intrigued.
The most obvious difference on this prototype is the slightly restyled front fascia with a smaller lower air inlet and the two-bar grille. Then we get to some of the car's mysterious details. For starters, this fascia has the SS vent above the grille, but it looks to be blocked off. Granted this could just be a one-off piece used for testing. What really piqued our interest was at the rear of the car where it has quad exhaust outlets that are used on the ZL1. Could this be the LS7-powered Camaro that we reported on back in December?
At this point, your guess is as good as ours as to what we're looking at here, so let us know in the comments what you think this could be.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck