Find or Sell Used Cars, Trucks, and SUVs in USA

1961 Chevrotet Apache30 Wrecker W/350 Engine (vin on 2040-cars

Year:1961 Mileage:0
Location:

Norcross, Georgia, United States

Norcross, Georgia, United States
Advertising:
Transmission:Manual
Vehicle Title:Clear
Engine:350
Fuel Type:Gasoline
For Sale By:Private Seller
VIN: 1C363A108924 Year: 1961
Number of Cylinders: 8
Make: Chevrolet
Model: Other Pickups
Warranty: Vehicle does NOT have an existing warranty
Trim: wracker
Drive Type: RWD
Mileage: 0
Condition: UsedA vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections.Seller Notes:"Truck is not completely restored. Please see pictires."

http://youtu.be/7c9y8hvAneA  

This 1961 Apache Custom has had all kinds work done .Ready to hit the road or work.350 engine runs great,no smoke no ticks,Runs cool with New Alum. rad. New HEI dist,New Alternator.Strong battery.Transmission is Heavy duty 4 speed with a granny low,1st gear.Clutch is strong.Holmes 440 Wrecker assembly w/PTO winch 1/2 inch cable,that will pull anything.all in very good working condition.Elec brake lock.New rubber sling,new push bumper rubber cover.All new brakes and w/hoses and wheel clys.All 6 wheels have been replaced and painted ,Tires are like new.New seat,and rubber floor mat,all pedals and shifter boot has been replaced.New exhaust.All door weather strips replace also window felt.and ft and rear windshield rubber seals replaced.All door handles new.All new Lights.PTO cable new.Speedo cable new and works.new vent cables.New gas tank unit and fuel gauge works.Floor parking brake works.New rocker panels inner and outer.I have all kinds of receipts for parts . Owner manual.You will be surprised at this old wrecker. Lots of fun. Always gets attention.Would be a hit at any car event. Georgia State does not issue titles for the vehicles of those years. The buyer will be provided with the bill of sale and  current registration.Exempt miles. Thanks for looking.

Auto Services in Georgia

Wheel Wizard ★★★★★

Automobile Body Repairing & Painting, Automobile Machine Shop, Wheels
Address: 3695 Longview Drive, Atlanta
Phone: (770) 451-6333

Uzuri 24-HR Plumbing ★★★★★

Auto Repair & Service
Address: 7854 Diamond Head Cir, Scottdale
Phone: (678) 778-8890

Used tires Atlanta ★★★★★

Automobile Parts & Supplies, Automobile Accessories
Address: 709 Memorial Dr SE, Forest-Park
Phone: (404) 932-1485

ultimateworks ★★★★★

Auto Repair & Service, Automobile Diagnostic Service, Auto Oil & Lube
Address: 5945 memorial dr, Pine-Lake
Phone: (770) 256-3368

Tyrone Auto Mobile Repair ★★★★★

Auto Repair & Service, Brake Repair, Automotive Roadside Service
Address: 3120 Forrest Hill Dr., Hapeville
Phone: (770) 689-9833

Top Quality Car Care ★★★★★

Auto Repair & Service, Automobile Electric Service, Automobile Inspection Stations & Services
Address: 276 North Glynn Street, Turin
Phone: (770) 406-6897

Auto blog

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

Mon, 04 Feb 2013

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.

Pony cars, trucks and Italian SUVs | Autoblog Podcast #552

Fri, Aug 31 2018

On this week's Autoblog Podcast, Editor-in-Chief Greg Migliore is joined by Senior Editor Alex Kierstein and Associate Editor Reese Counts. We discuss the updated 2019 Chevy Camaro Turbo 1LE variant, the new 2019 GMC Sierra Denali, and the Ferrari-powered Maserati Levante GTS. We also debate whether Volkswagen should build the Atlas-based Tanoak pickup truck and what a delay means for the next-gen Ford Mustang. Finally, we answer a reader question about the state of Lexus.Autoblog Podcast #552 Get The Podcast iTunes – Subscribe to the Autoblog Podcast in iTunes RSS – Add the Autoblog Podcast feed to your RSS aggregator MP3 – Download the MP3 directly Rundown 2019 Chevy Camaro Turbo 1LE 2019 GMC Sierra 2019 Maserati Levante GTS Should Volkswagen build the Tanoak? Next-gen Ford Mustang delayed The past, present and future of Lexus Feedback Email – Podcast@Autoblog.com Review the show on iTunes Related Video: Podcasts Chevrolet Ford GM GMC Lexus Maserati RAM Truck Coupe SUV Luxury Performance

GM to build outgoing Silverado and Sierra until late 2019

Tue, Nov 6 2018

As it has done with previous generations, General Motors is keeping the outgoing versions of its 1500 pickups in production despite the arrival of the all-new 2019 Chevrolet Silverado and 2019 GMC Sierra. The production of the previous, K2 generation models will begin to be wound down gradually, according to Automotive News, starting with crew cabs "early next year," and double and regular cab models following during "the early second half of next year." The old model trucks will continue to be built into "late 2019" based on market demand, GM's spokesperson Kim Carpenter said. The Chevrolet will go by the name Silverado LD, with the GMC Sierra designation still to be announced. Some of the outgoing models are built by sharing the assembly work between two GM plants. Partially finished Silverado and Sierra double cab bodies are shipped from Fort Wayne, Ind., to Oshawa, Ont., where the trucks are completed, including receiving paint. This eases the workload in Fort Wayne, where production of the new T1 generation trucks started in July 2018. In January, the Silao plant in Mexico will take on the duties of building new generation regular cab and crew cab trucks. Carpenter also said that the "Oshawa shuttle," as the shared production is called, has been very successful. As a result, 60,000 more trucks will be built than what the original production forecast initially called for. GM's latest quarterly profits, disclosed last week to be $1 billion, have been far higher than expected and will result in full-year profits far higher than what had been predicted in light of steel tariffs. GM isn't the only truck maker taking a similar multi-generation approach for 2019. Both the outgoing and redesigned Ram 1500 are in production, with the previous generation being dubbed Ram 1500 Classic. Related Video: