1946 Chevy Show Truck on 2040-cars
Wichita, Kansas, United States
beautiful completely restored show truck. budnik wheels. walnut bed.
|
Chevrolet Other Pickups for Sale
- 1958 chevrolet truck 3100 standard cab pickup 2-door(US $10,500.00)
- 1988 chevy scottsdale stepside short bed
- Frame up restoered museum quality 54 chevrolet 3100 26k original miles flawless!(US $24,900.00)
- 1993 chevy sidestep(US $6,000.00)
- 2006 chevy kodiak c4500 4x4 crew cab hauler 4wd air cab duramax diesel only 29k(US $52,950.00)
- 1987 chevy pickup truck, short bed, 454 big block
Auto Services in Kansas
Shawnee Kawasaki Honda and Yamaha ★★★★★
S H A D Fleet Services Inc ★★★★★
Petersen`s Small Engine Repair ★★★★★
Parkway Service Center ★★★★★
Lowe Auto ★★★★★
Legacy Auto Center ★★★★★
Auto blog
Next-gen Chevy Silverado and GMC Sierra may use carbon fiber
Thu, Dec 7 2017It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck
Chevy might've pulled out of NASCAR if it weren't for new Gen 6 car
Wed, 20 Feb 2013We've been on the fence with NASCAR for some time now. On one hand, it's some of the closest racing anywhere in motorsports, with actual passing and door-handle-to-door-handle action as a matter of course. But on the other, it's become template racing - a personality-driven sport more about the drivers than any sort of loyalty to a particular automaker. The Car Of Tomorrow format really rammed that message home, with a racecar's identity coming down to little more than headlamp stickers slapped on the nose. That's not necessarily a bad thing in and of itself, but we've wondered for some time what's in it for the automakers, who pay big money to stay in a series that has had little increasingly little do with street car sales, let alone innovation.
Apparently General Motors was beginning to wonder the same thing. In a new ESPN report, Rick Hendrick, team owner of Hendrick Motorsports, suggests that GM would have seriously considered leaving NASCAR if it wasn't for the move away from the COT to the new Gen 6 racer. According to Hendrick, GM North America boss Mark Reuss spearheaded the charge away from the 2007 COT and toward a racecar with clearer automaker ties - cars like the new Chevrolet SS racer shown above. Learn more about the fight for a closer-to-production look in the ESPN story at the link.
Now, if we could just get more rear-wheel drive V8 coupes into showrooms....
Nissan Leaf hits 3,000 sales in July, Chevy Volt climbs over 2,000
Fri, Aug 1 2014It was a good sales month for both the Nissan Leaf and the Chevy Volt, with the two 'elder statesman' plug-in vehicles reaching numerical milestones in July. The Leaf sold 3,019 units and the Volt crossed the 2,000 sales level for the first time in 2014, hitting 2,020 sales. With Tesla also announcing it is delivering around 2,500 Model S EVs a month (but that's globally, compared to the US-only numbers for the Volt and Leaf we're talking about here) and Ford's plug-in vehicles selling well, we are certainly in a golden moment for EV sales. The Volt was a bright spot for the Bowtie brand last month. For the Volt, the 2,020 units sold represents a 13 percent increase from July of 2013 even thought year-to-date sales are down 8.7 percent this year compared to last year. Overall, total Chevrolet deliveries for July 2014 were up eight percent compared to 2013, so the Volt was a bright spot for the Bowtie brand last month. On the Leaf front, this is only the second time that the EV has sold more than 3,000 units in a month (the other being in May of this year). The year-over-year increase for the Leaf was 62 percent in July and represents the 17th straight month of record sales, as Nissan is more than happy to report each month. Overall, Leaf sales are up 34.6 percent, year-to-date, and Nissan's director of Leaf sales and infrastructure, Brendan Jones, said in a statement that a free public charging incentive was responsible. "Since we launched the No Charge to Charge promotion in the first 10 markets, we've seen a surge in Leaf sales in those areas. Leaf sales in the northeastern US are also picking up with new tax incentives for Massachusetts and Maryland residents." With No Charge To Charge set to expand to 25 markets over the next year, we expect Leaf sales to continue to grow. We will have our monthly look at all green car sales available soon, so stay tuned. Green Chevrolet Nissan Electric PHEV ev sales