1966 Chevy Nova Two-door Post 383 Stroker Motor 350 Turbo Trans. White On Blue on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Chevy might've pulled out of NASCAR if it weren't for new Gen 6 car

We've been on the fence with NASCAR for some time now. On one hand, it's some of the closest racing anywhere in motorsports, with actual passing and door-handle-to-door-handle action as a matter of course. But on the other, it's become template racing - a personality-driven sport more about the drivers than any sort of loyalty to a particular automaker. The Car Of Tomorrow format really rammed that message home, with a racecar's identity coming down to little more than headlamp stickers slapped on the nose. That's not necessarily a bad thing in and of itself, but we've wondered for some time what's in it for the automakers, who pay big money to stay in a series that has had little increasingly little do with street car sales, let alone innovation.
Apparently General Motors was beginning to wonder the same thing. In a new ESPN report, Rick Hendrick, team owner of Hendrick Motorsports, suggests that GM would have seriously considered leaving NASCAR if it wasn't for the move away from the COT to the new Gen 6 racer. According to Hendrick, GM North America boss Mark Reuss spearheaded the charge away from the 2007 COT and toward a racecar with clearer automaker ties - cars like the new Chevrolet SS racer shown above. Learn more about the fight for a closer-to-production look in the ESPN story at the link.
Now, if we could just get more rear-wheel drive V8 coupes into showrooms....

2014 Chevrolet Silverado tows in new configurator, microsite

Judging by your continued enthusiastic response to configurator notices, dear reader, you enjoy speccing out new cars as much as we do. Better still, there tends to be even more ways to personalize, configure and bloat theoretical MSRPs on full-size trucks as there are with more ordinary passenger cars. In addition to trim level, engine and transmission choices, truck buyers usually have to specify items like cab configuration, bed length, number of driven axles, tow packages, gear ratios and all sorts of bits and bobs.
That's why we're pleased to see the DIY specification utility for the 2014 Chevrolet Silverado come alive so soon after this week's Detroit Auto Show debut. While the configurator lacks pricing (General Motors hasn't announced numbers yet) and full options, you can still spec out your half-ton rig, and even print it out or email it to your friends. Beyond the configurator, the new model-specific site is pretty cool, too, with various videos and closer looks at the truck's new features.
The new Chevrolet pickup range won't be on dealer lots until sometime this summer, so whether you're a building contractor, an avid sportsman or just a guy or gal that loves full-size trucks, you might want to check out the link below to keep your appetite whetted. If you're more of a Sierra fan, well, it looks like you're going to have to wait a while - GMC hasn't updated its site yet.