1987 Monte Carlo Ss on 2040-cars
Long Grove, Iowa, United States
Body Type:Coupe
Vehicle Title:Clear
Engine:355 chevy sb
Fuel Type:Gasoline
For Sale By:Private Seller
Make: Chevrolet
Model: Monte Carlo
Trim: SS Coupe 2-Door
Options: CD Player
Power Options: Cruise Control, Power Windows
Drive Type: rwd
Mileage: 51,000
Exterior Color: Black
Disability Equipped: No
Interior Color: Gray
Number of Doors: 2
Number of Cylinders: 8
Warranty: Vehicle does NOT have an existing warranty
Chevrolet Monte Carlo for Sale
- 2003 chevrolet monte carlo jeff gordon edition 4,000 miles!!!
- 1978 chevy monte carlo(US $25,000.00)
- 2002 chevrolet monte carlo ss pace car limited edition 3.8 liter v6 very nice
- 1972 chevy monte carlo
- 21,459 original mile 1 owner 1988 monte carlo ss buckets console t-top loaded!(US $14,900.00)
- 2002 chevrolet monte carlo ls coupe 2-door 3.4l
Auto Services in Iowa
Yaw`s Auto Salvage ★★★★★
Yaw`s Auto Salvage ★★★★★
Sinaloa Auto Sales ★★★★★
Scotty`s Body Shop ★★★★★
Rick`s Auto Sales ★★★★★
Merfeld Brothers Automotive ★★★★★
Auto blog
Next-gen Chevy Silverado and GMC Sierra may use carbon fiber
Thu, Dec 7 2017It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck
Next-gen Chevy Cruze caught cruising in the cold
Wed, 13 Feb 2013Spy photographers have caught what looks like the next-generation Chevrolet Cruze out on snow patrol. The camo could be tricking our eyes, but it look like it has an even tidier, more rounded front end and even lower fenders in relation to the top of the hood. And either a chunk of camo has been wedged between the side mirrors and the doors, or the mirrors are up for revision, too.
The door handles have been moved up the side of the car, leading the way to a rear end that grows a bit in length. If the rumors are true, the coming second-generation Cruze sits on the new D2XX platform that will replace the Delta and Theta platforms at General Motors. A global architecture, the Cruze will be the first to get it, but it will underpin everything from next Chevrolet Volt to the Equinox and could be responsible for 2.5 million units by 2018. The next Cruze is expected to begin production in GM's Lordstown, Ohio plant in the third quarter of 2014.
GM finds steering flaw, decides it doesn't warrant a recall
Tue, Apr 14 2015Guess what? General Motors is back in the spotlight for not recalling something. This time, though, not only does the company have an argument against a recall campaign, but its position is supported by the National Highway Traffic Safety Administration. According to The New York Times, over 50 owners of GM vehicles have reported instances of stuck or seized steering after driving long distances without moving the wheel. One owner complained to NHTSA that the "locked" steering of their 2013 Buick Verano caused a collision with a concrete barrier in a construction zone. Along with the 2013 to 2014 model year Verano sedans, Chevrolet Cruze and Malibu sedans are also affected. Considering the popularity of those models, GM needs to have a reason for not issuing a recall, right? "Based on a very low rate of occurrence – ranging from less than one half to less than two incidents per thousand vehicles – and the fact that the condition is remedied when the wheel is turned, GM determined this was not a safety issue," spokesman Alan Adler told The Times. The company has, however, issued a technical service bulletin for owners that complain of the problem. The fix is nothing more than a software update that is covered for 10 years or 150,000 miles from new. NHTSA cited GM's actions, along with descriptions of the problems from customers, in its decision not to issue a recall, with spokeswoman Catherine Howden saying, "the symptoms described would be a brief, perceptible change in steering feel that has little to no effect on the driver's ability to safely steer the vehicle." "When terms like 'notchy,' 'stick,' 'slip' or 'feel' are used, it does not indicate a meaningful increase in steering effort," Howden told The Times via email. What do you think? Is GM in the wrong here? Should there be a recall, or is the issue so limited as to not warrant one? Have your say in Comments. Featured Gallery 2013 Buick Verano Turbo: Review View 20 Photos Related Gallery 2014 Chevrolet Malibu: First Drive View 36 Photos Related Gallery 2014 Chevrolet Cruze Turbo Diesel: Quick Spin View 14 Photos News Source: The New York TimesImage Credit: Copyright 2015 Steven J. Ewing, Seyth Miersma / AOL Government/Legal Recalls Buick Chevrolet GM Safety Sedan buick verano