Find or Sell Used Cars, Trucks, and SUVs in USA

1976 Chevrolet Monte Carlo Landau Coupe 2-door 5.7l on 2040-cars

US $10,500.00
Year:1976 Mileage:48881
Location:

Accord, New York, United States

Accord, New York, United States
Advertising:

Purchased from original owner in West Virginia. 48,000 original miles All original interior, no rust. Clean undercarrage, Solid frame. Excellent Condition. Always Garage Kept. Comes with car cover.  Buyer responsable for shipping.  Payment accepted from a bank check with in 10 days.

Auto Services in New York

Zafuto Automotive Service Inc ★★★★★

Auto Repair & Service
Address: 7400 Porter Rd, Ransomville
Phone: (716) 297-0607

X-Treme Auto Glass ★★★★★

Automobile Parts & Supplies, Glass-Auto, Plate, Window, Etc, Windshield Repair
Address: 2561 Genesee St, Athol-Springs
Phone: (716) 542-1100

Willow Tree Auto Repair ★★★★★

Auto Repair & Service, Engine Rebuilding & Exchange, Auto Engine Rebuilding
Address: 248 Lansingville Rd, Lansing
Phone: (607) 533-3525

Willis Motors ★★★★★

Used Car Dealers
Address: 1128 Dix Ave, Hudson-Falls
Phone: (866) 595-6470

Wicks Automotive Inc ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Automobile Accessories
Address: 1159 Kennedy Blvd, Castleton
Phone: (201) 339-4668

Whalen Chevrolet Inc ★★★★★

Auto Repair & Service, New Car Dealers, Automobile Body Repairing & Painting
Address: 1528 State Route 29, Galway
Phone: (518) 692-2241

Auto blog

New Takata problem results in recall of 414 GM vehicles

Mon, Oct 19 2015

An airbag-inflator rupture discovered by Takata during testing has resulted in a new recall affecting 414 vehicles from General Motors, including 395 of them in the US. This latest campaign covers 2015 model-year examples of the Buick LaCrosse, Cadillac XTS, Chevrolet Camaro, Equinox, Malibu, and GMC Terrain. There are no reported breaks in any of these vehicles on the road, and the company estimates only one percent of them actually have the faulty parts. According to documents submitted to the National Highway Traffic Safety Administration (as a PDF), one side-airbag inflator failed a cold test at -40 Fahrenheit "releasing high pressure gas and propelling the separated components apart." The supplier told GM about the failure the next day. In these vehicles, the safety device might not only burst but the bag could inflate incorrectly, as well. GM and Takata say that a cause is not yet known, but they are "conducting an investigation." GM will begin notifying affected owners via overnight mail on Oct. 19. Dealers will replace the side airbag modules on all of the affected vehicles with new components outside of the suspect lot. All of the removed parts will also be collected for further study. Takata's faulty front airbag inflators have resulted in a serious scandal for the supplier. Initial figures indicated 34 million US vehicles are need of repair, though more recent figures have knocked that down to 23.4 million bad parts in 19.2 million automobiles. GM was already among the dozen automakers with models to fix, and some of its pickups were affected, along with the Saab 9-2X and Pontiac Vibe. GM Statement: General Motors is recalling 395 cars and crossovers in the U.S. because one of the front seat side air bags inflators may be defective. In the event of a deployment, the air bag's inflator may rupture and the air bag may not properly inflate. The rupture could cause metal fragments to strike the vehicle occupants, potentially resulting in serious injury or death. GM is unaware of any incidents involving vehicles with these components, which were part of a lot in which one inflator failed acceptance testing at the supplier. Dealers will replace the side air bag module or modules in affected vehicles. Including Canada, Mexico and exports, the total population of the recall is 414, GM estimates 1 percent of the recalled vehicles may have the defect.

CA Chevy dealer allegedly adds $50K 'market value adjustment' to 2015 Z06

Fri, Jan 9 2015

It seems to happen with every eagerly anticipated new car – dealerships, recognizing that crushing demand far outstrips the initial limited supply of a new model, inflate the price via a so-called "market value adjustment." We've seen it in the past with a number of new models, and now it's happening again with one of the Detroit 3's hottest vehicles. A dealership in Roseville, CA, outside of Sacramento, has allegedly attached a staggering $49,995 market value adjustment to a 2015 Corvette Z06. We say allegedly because, despite the evidence uncovered by BoostAddict, John L. Sullivan Chevy's online inventory listing doesn't display the price premium of the Z06 in question, a (normally) $93,965 model with the top-end 3LZ trim. It's unclear if either of the dealer's other Z06s, both 3LZs, one of which is in transit, will receive similar price adjustments. Now, legally, Sullivan Chevy isn't doing anything wrong here. Dealerships are under no obligation to observe a manufacturer's suggested retail price, a point General Motors' spokesperson Ryndee Carney pointed out to Autoblog via email. "For the Corvette Z06, Chevrolet has established a Manufacturer's Suggested Retail Price we feel is right for the market. Actual transaction prices, however, are the province of the dealer," Carney said, adding that a dealer zone manager will be discussing the price hike with the dealership. While we also reached out to the dealership over both the market value adjustment and the price of the Z06 as it appears on the company's website, we've yet to hear back as of this writing. Should they reply to our inquiries, we'll be sure to update you. Until then, we'd like to hear what you think about this case. Is Sullivan Chevy simply pricing the cars as high as it thinks the market can bear, or is this a cash grab for an hotly anticipated product? Have your say in Comments.

Why does the Corvette Stingray have so many vents? Here's why

Sun, 27 Jan 2013

Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.