2014 Chevrolet Malibu 1ls on 2040-cars

Auto blog

'84 MotorWeek Cherokee, Bronco and Blazer comparison indulges your SUV nostalgia

These days, truck-based, full-frame SUVs are somewhat of a rarity on the auto landscape due to the rapid rise in popularity of easier-driving, car-based crossovers. Although, without the gradually building popularity of these chunky, high-riding vehicles decades ago, it's unlikely that America's roads would be filled with so many CUVs today. In its latest dig into the archives, MotorWeek has found a 1984 comparison test of a trio of these early Sport Utility Wagons, as long-time host John Davis called them, that helped get acceptance of this segment going. This is a red, white and blue test of the SUVs from American automakers at the time and pits the Chevrolet Blazer, Ford Bronco and Jeep Cherokee (specifically in Wagoneer guise) against each other. Driving manners and interior usability are considered in the evaluation, but Motorweek actually takes these vehicles off road, too. Among the bigger revelations is the improvement in on-road ability in the past 30 years. While specific 0-60 times aren't given, all three models take around 10 seconds just to get to around 50 miles per hour in the 500-feet on-ramp acceleration test. Check out this clip to see just how far this segment has progressed in the past three decades or just get a blast of nostalgia from these now vintage models. News Source: MotorWeek via YouTube Chevrolet Ford Jeep SUV Off-Road Vehicles Classics Videos Ford Bronco chevy blazer

Thanks for keeping us on our toes, Detroit Auto Show [w/poll]

Here at Autoblog, we love unexpected debuts at auto shows – and judging by our Detroit Auto Show comments and traffic, you do, too. Surprise reveals have been fewer and farther between in recent years with so many ways for vehicles to be teased or leak out, but this week's show has been a revelation. More to the point, it's been a series of revelations, with automakers from around the globe successfully delivering a brace of concept and production surprises. It's made our jobs a lot more exciting and challenging this week, and even though it's actually more work to react and run-and-gun when the sheet is pulled on a surprise reveal than it is to publish an already-written embargoed story, we've had more fun covering this show for you than any domestic show in memory. We hope you've enjoyed the surprises along with us. To that end, borrowing the words of an unnamed automaker PR flack, we'd like to thank the following automakers for enduring "mountain of antacids" and that "creeping sense of paranoia" necessary to keeping ones' wares totally under wraps until the sheets are pulled off the sheetmetal: Buick Avenir concept Chevrolet Bolt concept Ford GT concept Ford Mustang Shelby GT350R Ford F-150 SVT Raptor Hyundai HCD-15 Santa Cruz concept And while we're at it, we'd like to throw in an shout-out to Detroit's substantially revised and revitalized Cobo Center, and in particular, the redone Michelin media center, which is arguably the single best accommodations for writing show stories that we've encountered on the entire international circuit. Well done, everyone. Thank you, and keep the surprises coming. Auto News Detroit Auto Show Buick Chevrolet Ford Hyundai Volvo 2015 Detroit Auto Show

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck