Find or Sell Used Cars, Trucks, and SUVs in USA

All Original Ss on 2040-cars

US $19,000.00
Year:1965 Mileage:147778
Location:

United States

United States
Advertising:

1965 impala ss needs paint and muffler and a little detail. All original, numbers match.

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

Thu, Dec 7 2017

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Watch the National Corvette Museum sinkhole being filled in by R/C cars

Sun, Jan 11 2015

Okay, so not exactly cars, but Bobcats - but still quite cool. You might remember that the National Corvette Museum had that little divot that needed to be filled in. Turns out the construction firm of Scott, Murphy & Daniel doing the work is using two remote-controlled Bobcats to fill the sinkhole with "manufactured sand," which in this case is crushed limestone. It appears that the Bobcat company has offered remote operation since at least 2007 via a wireless transmitter that works up to 1,500 feet away. So yes, that means two SMD employees stand on the edge of the pit and flick joystick levers for hours at a time, one in charge of a Bobcat with a roller-compactor attachment, the other in charge of a Bobcat with a bucket. And that, to us, is a pretty good way to earn the daily bread. Check out the video above for the latest sinkhole update. News Source: National Corvette Museum via YouTube Auto News Weird Car News Chevrolet GM Videos rc car remote control National Corvette Museum bobcat ncm

GM recalls Cadillac ATS and Chevy Impala for separate issues

Fri, Feb 27 2015

The National Highway Traffic Safety Administration added two recalls from General Motors in the government organization's daily update of safety campaigns. Both were for failing to meet Federal Motor Vehicle Safety Standards but for completely separate reasons. The larger recall covers 58,698 units of the 2013-2015 Cadillac ATS, but it doesn't really carry huge safety concerns. In vehicles produced between April 25, 2012, and February 9, 2015, the controls for the tilt and slide of the moonroof are not recessed enough, as required by federal law. According to NHTSA, it's possible that someone could inadvertently activate the auto-close for the roof panel, which the agency claims increases "the risk of personal injury." Dealers will install a new trim plate that will add the necessary clearance. The other campaign covers 1,177 examples of the 2014 Chevrolet Impala from between November 15, 2012, and May 27, 2014. However, this is actually a repeat of a previous recall on the Chevy and the Cadillac XTS from 2014. The affected Impalas here "were remedied incorrectly" under the earlier campaign, according to NHTSA. On these sedans, it's possible the electronic parking brake might not fully disengage and still remain in some contact with the rotor, which is in violation of federal rules. The fault can cause excessive heat from the brakes that could potentially lead to a fire, according to NHTSA. To fix the problem, dealers will reprogram the electronic parking brake control module. Show full PR text RECALL Subject : Inadvertent Press of Roof Panel Switch/FMVSS 118 Report Receipt Date: FEB 24, 2015 NHTSA Campaign Number: 15V106000 Component(s): VISIBILITY Potential Number of Units Affected: 58,698 All Products Associated with this Recall Vehicle Make Model Model Year(s) CADILLAC ATS 2013-2015 Details Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2013-2015 Cadillac ATS vehicles manufactured April 25, 2012, to February 9, 2015. In the affected vehicles, the power-operated roof panels auto-close when the non-recessed "Slide" or "Tilt" switches are pressed. As such, these vehicles fail to comply with the requirements of the Federal Motor Vehicle Safety Standards (FMVSS) No.