1965 Chevrolet Impala Base Hardtop 2-door 4.6l on 2040-cars
Warren, Michigan, United States
Body Type:Hardtop
Vehicle Title:Clear
Engine:V8 283
Fuel Type:GAS
For Sale By:Private Seller
Number of Cylinders: 8
Make: Chevrolet
Model: Impala
Trim: n/a
Drive Type: RWD
Mileage: 114,071
Disability Equipped: No
Exterior Color: Gray
Warranty: Vehicle does NOT have an existing warranty
Interior Color: Burgundy
This is a 1965 Chevrolet Impala (not an SS) posted for sale by owner. It DOES NOT have the original interior I think the previous owner put an interior from an 80 something olsmobile in it. It has a strong running 283 V8 but im not sure if it's numbers matching. CAR RUNS AND DRIVES I DROVE IT OVER 150 MILES BACK HOME WHEN I PURCHASED SO TRANSPORTING SHOULDN'T BE A PROBLEM
Chevrolet Impala for Sale
Auto Services in Michigan
Westside Collision Service ★★★★★
Vision Collision ★★★★★
Venom Motorsports Inc ★★★★★
Vehicle Accessories ★★★★★
Tuffy Auto Center Novi ★★★★★
Transmission Shop ★★★★★
Auto blog
GM recalling 1.4 million older vehicles for oil leak fire risk
Tue, Oct 27 2015General Motors is recalling 1,411,332 older vehicles with its 3.8-liter V6 yet again due to a fire risk. Specifically, there are 1,283,340 of them in the US, and the affected models are the: 1997-2004 Pontiac Grand Prix 2000-2004 Chevrolet Impala 1998-1999 Chevrolet Lumina 1998-2004 Chevrolet Monte Carlo 1998-1999 Oldsmobile Intrigue 1997- 2004 Buick Regal The fault with these vehicles is that oil can drip onto the hot exhaust manifold during hard braking, which can potentially cause of fire. In the last six years, there have 19 reported minor injuries from this problem but no crashes or fatalities, according to the company. Spokesperson Alan Adler also told Autoblog: "GM has reports of 1,345 fires in vehicles that were repaired under two previous recalls for this issue." At this time, GM is still developing a remedy for the problem. According to Adler, the company advised owners to park these vehicles outside for the previous recalls. "The cars can be safely driven. In cases where a customer reported an engine fire while driving, smoke was reported, which would be an indication of a malfunction," he said. This is GM's fourth recall for this problem since 2008, according to The Detroit News. At one point it was believed that aging valve cover gaskets allowed the oil to leak out and drip onto the manifold. A campaign in 2009 covered nearly 1.5 million of these models through the 2003 model year for the same issue. At the time, dealers installed new spark plug wire retainers as a fix. Related Video: GM Statement: General Motors is recalling 1,283,340 older sedans and coupes in the U.S. from the 1997 to 2004 model years because drops of oil may be deposited on the hot exhaust manifold through hard braking, which can cause engine compartment fires. GM is working on a remedy. The company is aware of post-repair fires in some vehicles but no crashes or fatalities. There have been 19 reported minor injuries over the last six years. These vehicles with 3.8-liter V6 3800 engines are affected: 1997-2004 Pontiac Grand Prix, 2000-2004 Chevrolet Impala, 1998-1999 Chevrolet Lumina and 1998-2004 Chevrolet Monte Carlo, 1998-1999 Oldsmobile Intrigue and 1997-2004 Buick Regal. Including Canada, Mexico and exports, the total population is 1,411,332.
GM reintroduces Tripower name in the worst way possible
Wed, Aug 1 2018The story of General Motors' use of the Tripower moniker begins way back in 1957, when Semon E. "Bunkie" Knudsen, then General Manager of GM's Pontiac division, directed his engineers to inject more performance into his brand's line of V8-powered automobiles. Fuel injection was an option, but hot rodders flocked instead to Tri-Power (marketed way back when with a hyphen), which grafted a trio of two-barrel Rochester carburetors onto a single intake manifold. A legend was born. And that legend was born of performance. At idle and when full power wasn't required, Pontiac's Tri-Power system used just the middle carburetor, which helped make the setup easier to tune. Depending on the year and model, either a vacuum system or a mechanical linkage opened up the two outer carbs, thereby switching from two barrels to six, and allowing the engine to take in more fuel and air. And it was an easy marketing win – six barrels is better than four barrels, right? Because performance! So, when news filtered in that GM has resurrected the Tripower name, those of us who grew up attending classic car shows and wrenching on old Pontiacs did a double-take. And then we all collectively sighed. Turns out that today's Tripower refers to a trio of fuel-saving measures that include cylinder deactivation, active thermal management, and intake valve lift control, according to Automotive News. And, at least for now, it applies to GM's line of fullsize trucks powered by a 2.7-liter turbocharged four-cylinder engine. We're all for saving fuel whenever possible. And we have zero say in how any automaker chooses to market its products and technologies. But, we'll offer our two cents anyway: Relaunching a storied name from the past is fine. Relaunching a storied name from the past while completely overlooking the reasons the name got famous in the first place is only going to irritate the people who remember the name in the first place. Couldn't they just call this new technology package something else? Related Video: News Source: Automotive NewsImage Credit: Getty Green Marketing/Advertising Chevrolet GM Pontiac Automotive History Truck chevrolet silverado
Even if GM does close all 5 of those plants, it'll still have too many
Wed, Nov 28 2018DETROIT — General Motors' monumental announcement on Monday that it will close three car assembly plants and two powertrain plants in North America and slash its workforce will only partially close the gap between capacity and demand for the automaker's sedans, according to a Reuters analysis of industry production and capacity data. Sales of traditional passenger cars in North America have been declining for the past six years and are still withering. After GM ends production next year at factories in Michigan, Ohio and Ontario, it will still have four U.S. passenger-car plants — all operating at less than 50 percent of rated capacity, according to figures supplied by LMC Automotive. In comparison, Detroit-based rivals Ford and Fiat Chrysler Automobiles will have one car plant each in North America after 2019. The Detroit Three are facing rapidly dwindling demand for traditional passenger cars from U.S. consumers, many of whom have shifted to crossovers and trucks. Passenger cars accounted for 48 percent of retail light-vehicle sales in the United States in 2014, according to market researchers at J.D. Power and Associates. This year, sedans will account for less than a third of light vehicle sales. That shift in turn has left most North American car plants operating far below their rated capacities, while many SUV and truck plants are running on overtime. The collapse in passenger-car demand is a challenge for nearly all automakers in the United States, including Japan's Toyota and Honda, which have the top-selling models in the compact and midsize car segments. Toyota executives said last month they are evaluating the company's U.S. model lineup. But Toyota also plans to build compact Corolla sedans at a new $1.6 billion factory it is building in Alabama with partner Mazda. The obstacles facing GM in its plans to close more auto factories became apparent on Tuesday as U.S. President Donald Trump threatened to block payment of government electric vehicle subsidies to GM. While it is not certain that Trump unilaterally has the power to do that, he made it clear he intends to use his office to pressure the company to keep open a small car plant in Ohio that GM says will stop building vehicles in March.