2008 Panel Lt Used 2.4l I4 16v Manual Fwd Suv Onstar 49k Miles on 2040-cars

Auto blog

Cruze Diesel Road Trip reveals the good and bad, but no ugly

Most of us have strong opinions on diesel-powered cars based on our perceptions of and experience with them. I used to thoroughly dislike oil burners for their noise, smoke and lackluster performance, and the fact that they ran on greasy, smelly stuff that was more expensive than gasoline, could be hard to find and was nasty to get on your hands when refueling. Those negatives, for me, trumped diesel's major positives of big torque for strong acceleration and better fuel economy. Are any of those knocks on diesel still valid today? I'm not talking semis, which continue to annoy me when their operators for some reason almost never shut them down. At any busy truck stop, the air seems always filled with the sound – and sometimes smell – of dozens of big-rig diesels idling endlessly and mindlessly. Or diesel heavy-duty pickups. Those muscular workhorses are far more refined than they once were and burn much less fuel than their gasoline counterparts. But good luck arriving home late at night, or departing early morning, without waking your housemates and neighbors with their clattery racket. No, I'm talking diesel-powered passenger cars, which account for more than half the market in Europe (diesel fuel is cheaper there) yet still barely bump the sales charts in North America. Diesel fuel remains more expensive here, too few stations carry it, and too many Americans remember when diesel cars were noisy, smelly slugs. Also, US emissions requirements make them substantially more expensive to certify, and therefore to buy. But put aside (if you can) higher vehicle purchase and fuel prices, and today's diesel cars can be delightful to drive while delivering much better fuel efficiency than gas-powered versions. So far in the US, all except Chevrolet's compact Cruze Diesel come from German brands, and all are amazingly quiet, visually clean (no smoke) and can be torquey-fun to drive. When a GM Powertrain engineering team set out to modify a tried-and-true GM of Europe turbodiesel four for North American Chevy Cruze compacts, says assistant chief engineer Mike Siegrist, it had a clear target in mind: the Volkswagen Jetta TDI 2.0-liter diesel. And they'll tell you that they beat it in nearly every way. "I believe we have a superior product," he says. "It's powerful, efficient and clean, and it will change perceptions of what a diesel car can be." The 2.0L Cruze turbodiesel pumps out 151 SAE certified horses and 264 pound-feet of torque (at just 2,000 rpm) vs.

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

2014 Chevy Cruze Diesel destined for Chicago debut

It's been a little over a year and a half since General Motors first confirmed plans to offer a diesel-powered Chevrolet Cruze here in the United States, and we've now learned that the oil-burning compact will debut under the lights of the Chicago Auto Show in February. According to GM Authority, the Cruze Eco-D will be introduced as part of the entire 2014 model year Cruze range, set to go on sale in the second quarter of this year.
Earlier reports have indicated that the diesel Cruze will be able to achieve fuel economy numbers in the range of 50 miles per gallon. For comparison, the similarly sized Volkswagen Jetta TDI is rated at 30/42 mpg city/highway, but as we found out in our long-term test of the 2011 model, hitting 50 mpg was a piece of cake.
Official specifications will be released at the time of the 2014 Cruze's unveiling, though reports have stated that the sedan will be powered by a reworked version of the 2.0-liter turbo-diesel inline-four found in the Holden Cruze CDX overseas. In that application, the four-pot oil-burner produces 160 horsepower and 265 pound-feet of torque - increases of 20 hp and 29 lb-ft over the 2.0-liter engine used in VW's Jetta TDI.