1998 Chevrolet G20 Van G2500 on 2040-cars

Auto blog

2021 Jeep Grand Cherokee L vs Big Three-Row Crossovers | Spec comparison

The three-row 2021 Jeep Grand Cherokee L is here, entering an ever-growing segment of big crossovers that Jeep has ignored since the Commander of the late 2000s. Of course, the Dodge Durango has basically been a three-row version of the current Grand Cherokee with Dodge styling and a different interior, so it's not like The Corporate Entity Formerly Known as Chrysler has been without a contender in the segment. Jeep is a stronger brand than Dodge, however, and the three-row midsize segment is stronger than those with two rows (there's a vast sales difference between the Chevrolet Traverse and Blazer, as well as the Honda Pilot and Passport). In other words, the Grand Cherokee L could be a very big deal. It is also, quite literally, a very big deal. As you're about to see, it is now the largest three-row crossover, besting the length, wheelbase and height of even the gargantuan Traverse. There's more to the story than that, however, so we put together the below comparison chart to show you how the new Grand Cherokee L lines up on paper versus the biggest three-row crossovers. That includes the 2021 Ford Explorer, 2021 Kia Telluride, 2021 Hyundai Palisade and 2022 Chevrolet Traverse. This group also represents some of the strongest entries in the segment as well as those we feel are most likely to be considered alongside the big Jeep. To that end, we also included the 2021 Lincoln Aviator in the chart since its base price is actually less than what we anticipate the luxurious, range-topping Grand Cherokee L Overland and Summit trim levels to start.  Engines and drivetrains Note the differences in curb weight here. The Grand Cherokee L has the highest base curb weight of the group apart from the high-lux Aviator, yet its 3.6-liter V6 has the least amount of power and torque. Therefore, it'll be surprising if it's not the slowest in the group. There's of course the Hemi V8 available on the top Overland and Summit trim levels, but again, a hefty curb weight works against it. At 5,330 pounds, the lightest V8-powered JGCL weighs 600 pounds more than V6-power Explorer Platinum and ST models. On the other hand, nothing can touch the Hemi Jeep's towing capacity, and only the 400-hp Aviator betters the Jeep's base V6. Its 6,200-pound towing capacity greatly outdoes the 5,000-pound limits of not only the Telluride, Palisade and Traverse, but most others in the segment as well.

Consumer Reports no longer recommends Honda Civic

Consumer Reports annual Car Reliability Survey is out, and yes, there are some big surprises. First and foremost? The venerable publication no longer recommends the Honda Civic. In fact, aside from the walking-dead CR-Z and limited-release Clarity fuel-cell car, the Civic is the only Honda to miss out on CR's prestigious nod. At the opposite end there's a surprise as well – Toyota and Lexus remain the most reliable brands on the market, but Buick cracked the top three. That's up from seventh last year, and the first time for an American brand to stand on the Consumer Reports podium. Mazda's entire lineup earned Recommended checks as well. Consumer Reports dinged the Civic for its "infuriating" touch-screen radio, lack of driver lumbar adjustability, the limited selection of cars on dealer lots fitted with Honda's popular Sensing system, and the company's decision to offer LaneWatch instead of a full-tilt blind-spot monitoring system. Its score? A lowly 58. The Civic isn't the only surprise drop from CR's Recommended ranks. The Audi A3, Ford F-150, Subaru WRX/STI, and Volkswagen Jetta, GTI, and Passat all lost the Consumer Reports' checkmark. On the flipside, a number of popular vehicles graduated to the Recommended ranks, including the BMW X5, Chevrolet Camaro, Corvette, and Cruze, Hyundai Santa Fe, Porsche Macan, and Tesla Model S. Perhaps the biggest surprise is the hilariously recall-prone Ford Escape getting a Recommended check – considering the popularity of Ford's small crossover, this is likely a coup for the brand, as it puts the Escape on a level playing field with the Recommended Toyota RAV4, Honda CR-V, and Nissan Rogue. While Ford is probably happy to see CR promote the Escape, the list wasn't as kind for every brand. For example, of the entire Fiat Chrysler Automobiles catalog, the ancient Chrysler 300 was the only car to score a check – there wasn't a single Dodge, Fiat, Jeep, Maserati, or Ram on the list. That hurts. FCA isn't alone at the low end, either. GMC, Jaguar Land Rover, Mini, and Mitsubishi don't have a vehicle on CR's list between them, while brands like Mercedes-Benz, Volvo, Nissan, Lincoln, Infiniti, and Cadillac only have a few models each. You can check out Consumer Reports entire reliability roundup, even without a subscription, here.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck