2008 Chevrolet Express 3500 Lt Standard Passenger Van 4-door 6.0l on 2040-cars

Auto blog

This 93-car Iowa auction is like a Big 3 classic muscle museum

Bill "Coyote" Johnson has been buying cars since high school and has amassed a collection totaling 113 vehicles, according to NBC 6 News. But time has changed his motivations and priorities, and he's decided to auction 93 of those cars, many of which are classic muscle from Ford, Chevrolet, Dodge, Plymouth and Pontiac. The megasale will take place Sept. 14, 2019, in Red Oak, Iowa, at the Montgomery County Fairgrounds. A 1969 Plymouth Road Runner infected Coyote with a love for Detroit muscle when he was just a teenager, and his desire quickly turned into an obsession. He's spent the past 40 years finding, buying and working on a variety of makes and models. Unlike some collectors, Coyote didn't discriminate against certain brands and has rides from each of the Big 3 automakers. Included in the auction are Camaros, Satellites, Super Bees, Chargers, Challengers, Barracudas, Coronets, GTOs, Mustangs, Cutlasses and others. Possibly the most intriguing aspect of the auction is that all of these cars will be sold as-is with no reserve. Many of them will need work, depending on quality standards, but this seems like a golden opportunity to find a classic car without leaving a bank account in shambles.  The auctions are open for bidding online now, and the full auction will take place on September 14. Check out the full listings and bid at VanDerBrink Auctions.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM recalls Cadillac ATS and Chevy Impala for separate issues

The National Highway Traffic Safety Administration added two recalls from General Motors in the government organization's daily update of safety campaigns. Both were for failing to meet Federal Motor Vehicle Safety Standards but for completely separate reasons. The larger recall covers 58,698 units of the 2013-2015 Cadillac ATS, but it doesn't really carry huge safety concerns. In vehicles produced between April 25, 2012, and February 9, 2015, the controls for the tilt and slide of the moonroof are not recessed enough, as required by federal law. According to NHTSA, it's possible that someone could inadvertently activate the auto-close for the roof panel, which the agency claims increases "the risk of personal injury." Dealers will install a new trim plate that will add the necessary clearance. The other campaign covers 1,177 examples of the 2014 Chevrolet Impala from between November 15, 2012, and May 27, 2014. However, this is actually a repeat of a previous recall on the Chevy and the Cadillac XTS from 2014. The affected Impalas here "were remedied incorrectly" under the earlier campaign, according to NHTSA. On these sedans, it's possible the electronic parking brake might not fully disengage and still remain in some contact with the rotor, which is in violation of federal rules. The fault can cause excessive heat from the brakes that could potentially lead to a fire, according to NHTSA. To fix the problem, dealers will reprogram the electronic parking brake control module. Show full PR text RECALL Subject : Inadvertent Press of Roof Panel Switch/FMVSS 118 Report Receipt Date: FEB 24, 2015 NHTSA Campaign Number: 15V106000 Component(s): VISIBILITY Potential Number of Units Affected: 58,698 All Products Associated with this Recall Vehicle Make Model Model Year(s) CADILLAC ATS 2013-2015 Details Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2013-2015 Cadillac ATS vehicles manufactured April 25, 2012, to February 9, 2015. In the affected vehicles, the power-operated roof panels auto-close when the non-recessed "Slide" or "Tilt" switches are pressed. As such, these vehicles fail to comply with the requirements of the Federal Motor Vehicle Safety Standards (FMVSS) No.