Find or Sell Used Cars, Trucks, and SUVs in USA

2007 Chevrolet G3500 Express Cutaway Truck 2-door 6.0l 195,405 - Bay Bridge Cube on 2040-cars

US $7,900.00
Year:2007 Mileage:195405
Location:

Hartsburg, Illinois, United States

Hartsburg, Illinois, United States

Auto Services in Illinois

World Class Motor Cars ★★★★★

New Car Dealers, Used Car Dealers
Address: 1245 Ogden Ave, Warrenville
Phone: (630) 493-1600

Wilkins Hyundai-Mazda ★★★★★

New Car Dealers, Used Car Dealers
Address: 750 N York St, Elmhurst
Phone: (630) 279-3000

Unibody ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting
Address: 1891 N Milwaukee Ave, Brookfield
Phone: (773) 235-1334

Turpin Chevrolet Inc ★★★★★

New Car Dealers, Used Car Dealers
Address: 1048 S Chicago St, Orion
Phone: (309) 944-2173

Tuffy Auto Service Centers ★★★★★

Auto Repair & Service, Brake Repair
Address: 6574 E Riverside Blvd, Garden-Prairie
Phone: (815) 639-1239

Triple T Car Wash Lube & Detail Center ★★★★★

Auto Repair & Service, Car Wash, Auto Oil & Lube
Address: 1905 W Bradley Ave, Champaign
Phone: (217) 352-9200

Auto blog

Motor Trend puts Chevy Camaro Z28 and Porsche 911 GT3 Head 2 Head

Mon, Dec 29 2014

Motor Trend admits, "This is an unfair comparison." But that doesn't make it any less fun to watch when they pit a Camaro Z/28 against the Porsche 911 GT3. The former has a 7.0-liter V8 with 505 horsepower and 481 pound-feet of torque shifted through a six-speed manual. The latter has a 3.8-liter flat-six with 475 hp and 324 lb-ft shifted through a seven-speed dual-clutch transmission. Yet those are only the little disparities – the big disparities are mass and money: the Camaro weighs 3,882 pounds and costs $76,150 as-tested, the Porsche weighs 3,267 pounds and costs $145,785. But they're both about hardcore performance, so MT takes them out on the street, to the drag strip, to the parking lot for figure eights and a skidpad test, and finally to Big Willow for Randy Pobst to give his professional assessment. Remember when a lotta people spent a lotta time debating Pirates vs. Ninjas? This is like that, only it's the "haul-ass good-time car" vs. the "track surgeon." Enjoy the debate in the video.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

Thu, Dec 7 2017

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Mysterious white powder discovered at GM Orion Assembly

Fri, Sep 2 2016

Workers at General Motors Orion Assembly Plant in Orion Township, MI uncovered a mysterious white powder in two different parts of the factory earlier this week, raising concerns about worker safety. "We can confirm that an unknown substance (white powder) was found on the floor outside of Gate 6 at Orion Assembly on Monday, August 29. On Tuesday, August 30, we had a second report of a bottle containing a similar substance found inside the plant," GM spokesperson Dayna Hart told The Oakland Press via email. GM stressed that incident didn't disrupt operations at the plant, and that the company was taking steps to ensure the safety of the sprawling factory's workers. That did include, an anonymous worker told The Oakland Press, closing off parts of the factory for two full days, as drug-sniffing dogs and crews in haz-mat suits descended on the area. "A sample of the substance has been sent to a laboratory for identification and results are expected later this week," Hart said. "All findings and actions have been shared with our employees." Orion Assembly currently builds the Chevrolet Sonic and Buick Verano, and will eventually be responsible for production of the new, all-electric Chevy Bolt early next year. Related Video: