1979 El Camino Pro Street Hot Rod on 2040-cars

Auto blog

Jaguar I-Pace vs. Tesla Model 3 and other EVs: How they compare on paper

The 200-mile club of electric vehicles is really growing. The most recent member is the Jaguar I-Pace, the company's first pure EV. It promises luxury, performance, style, and most important, good range. Nearly as recent is the Hyundai Kona EV, and while it doesn't promise luxury or performance like the Jaguar (it's also smaller), it does pack impressive range. With the introduction of both of these electric cars, we thought we would see how they compare against each other, and the other two big names in high-capacity electric cars: the Chevy Bolt EV and the Tesla Model 3. This isn't intended to be a direct, apples-to-apples comparison, as the four are quite different. If anything, they break into two groups: bigger and more luxurious, and smaller and less expensive. Then again, the number of vehicles with this electric range is small and comparisons to EV's with less range wouldn't be too kind to the other guys. If you want to learn more about these EVs, and compare them with other cars, be sure to check out our Car Finder and comparison tools. Horsepower and torque There is one clear winner here, and that's the Jaguar I-Pace. It packs a whopping 394 horsepower and 512 pound-feet of torque. That comes through a pair of electric motors (one at the front, another at the rear) that provide the Jag with all-wheel drive, the only one of these vehicles to offer it (at the moment). Altogether, it allows the I-Pace to have the best 0-60 mph time of 4.5 seconds. At the other end of the spectrum is the Hyundai Kona EV. It's front-drive, like the Bolt EV, and has effectively the same amount of horsepower as the Chevy at 201 horsepower, but its 0-60-mph time is almost a second slower. And the low-range version of the Kona, excluded because it doesn't go more than 200 miles between charges, is slower still. The Tesla Model 3 is the only vehicle with rear-wheel drive, and with a 0-60 mph of 5.1 seconds for the Long Range model, it is still very quick. Range and energy use Frequently, the all-consuming question with electric cars is, "How far can I go on a charge?" And to go the farthest, you need the long-range Tesla Model 3. It can go 310 miles. It has the added advantage of being able to use the network of Tesla Supercharger stations, though they are pay-per-use with the Model 3. Even the lower capacity Model 3, with just 220 miles of range, can use these stations.

GM recalls 83,572 SUVs for ignition switch issue

General Motors is recalling 83,572 SUVs from the 2011 and 2012 model years over a potential ignition lock actuator issue. In affected vehicles, the actuator isn't the right size, which could cause the ignition to get stuck in the "Start" position, and then either due to a jarring event or a "cool interior temperature" the ignition could switch back to the "Accessory" position. Doing so would cause a loss of power assistance and the airbags might not deploy. This is a different ignition issue than the one that's been ongoing for the past year. GM said it expects that less than 500 vehicles suffer from the problem, but that the pool could include vehicles from 2007 through to 2014 that have already been fixed, but with defective parts. The 2011-2012 SUVs included in the National Highway Traffic Safety Administration notice: Cadillac Escalade, Escalade ESV, Escalade EXT, Chevrolet Avalanche, Silverado HD, Silverado LD, Suburban, Tahoe, GMC Sierra LD, Sierra HD, Yukon, and Yukon XL vehicles. GM will notify owners and dealers will inspect the ignition lock housing to see if it needs a free replacement. RECALL Subject : Ignition Lock Actuator may Bind Report Receipt Date: DEC 30, 2014 NHTSA Campaign Number: 14V827000 Component(s): ELECTRICAL SYSTEM Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2011-2012 Cadillac Escalade, Escalade ESV, Escalade EXT, Chevrolet Avalanche, Silverado HD, Silverado LD, Suburban, Tahoe, GMC Sierra LD, Sierra HD, Yukon, and Yukon XL vehicles. In the affected vehicles, the ignition lock actuator may bind, making turning the key difficult or causing the ignition to get stuck in the "Start" position. CONSEQUENCE: If stuck in the "Start" position, the ignition may suddenly snap back into the "Accessory" position, causing a loss of engine, steering, and braking power, increasing the risk of a vehicle crash. If the vehicle is in a crash, the air bags may not deploy, increasing the risk of occupant injury. REMEDY: GM will notify owners, and dealers will inspect and replace the ignition lock housing, as necessary, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact GM customer service at 1-800-458-8006 (Cadillac), 1-800-222-1020 (Chevrolet), or 1-800-462-8782 (GMC). GM's number for this recall is 14696 for the original equipment, and 14912 for the service replacement parts.

GM adds 1,200 jobs at Detroit-Hamtramck plant

General Motors is making a big move at its Hamtramck, MI, factory, announcing it will add a second shift and hire over 1,200 workers within the next several months. It's expected that by early 2016, the factory will employ over 2,800 workers to build the Chevrolet Volt, Impala, Malibu, Cadillac ELR, and by early next year, the new CT6. According to GM Hamtramck spokesperson Courtney Zemke, 40 of the 1,200 positions are for salaried employees, while the remainder will be hourly positions. As for where these employees will go, positions are being made available across the factory, so GM isn't focusing on any particular area for its new hires. It's a similar story behind the hiring surge itself. GM said in its press release that the "second shift is necessary to meet forecasted market demand," a position Zemke reiterated. It's a matter of demand across the plant's portfolio, rather than any one particular product seriously outstripping supply. Naturally, the United Auto Workers is happy with the move. "The workforce at Detroit-Hamtramck is second to none," UAW Local 22 Shop Chairman Don LaForest said in the attached release. "We appreciate the opportunity to expand our UAW-GM family." Hiring is going on now, with the second shift slated to get underway in early 2016. GM's Detroit-Hamtramck Assembly to Add Second Shift and More Than 1,200 Jobs Plant will nearly double its workforce by early 2016 2015-10-22 DETROIT – General Motors is nearly doubling its workforce at Detroit-Hamtramck Assembly by adding a second shift and more than 1,200 hourly and salaried jobs. The addition of a second shift will increase the plant's workforce to approximately 2,800 people when hiring is completed. The second shift is necessary to meet forecasted market demand for the five cars produced at Detroit-Hamtramck. "This is the result of the award-winning vehicles Detroit-Hamtramck produces and the confidence GM has in our team to build world-class quality for our customers," said Plant Manager Gary West. Second shift hiring is underway, and the shift is scheduled to begin operations in early 2016. "The workforce at Detroit-Hamtramck is second to none," said UAW Local 22 Shop Chairman Don LaForest. "We appreciate the opportunity to expand our UAW-GM family." The 4.1 million-square-foot Detroit-Hamtramck Assembly opened in 1985. GM has invested $1 billion in the plant over the last six years, making it one of the company's most-agile manufacturing facilities in North America.