1977 El Camino Bucket Seat V8 350 on 2040-cars

Auto blog

GM recalls 83,572 SUVs for ignition switch issue

General Motors is recalling 83,572 SUVs from the 2011 and 2012 model years over a potential ignition lock actuator issue. In affected vehicles, the actuator isn't the right size, which could cause the ignition to get stuck in the "Start" position, and then either due to a jarring event or a "cool interior temperature" the ignition could switch back to the "Accessory" position. Doing so would cause a loss of power assistance and the airbags might not deploy. This is a different ignition issue than the one that's been ongoing for the past year. GM said it expects that less than 500 vehicles suffer from the problem, but that the pool could include vehicles from 2007 through to 2014 that have already been fixed, but with defective parts. The 2011-2012 SUVs included in the National Highway Traffic Safety Administration notice: Cadillac Escalade, Escalade ESV, Escalade EXT, Chevrolet Avalanche, Silverado HD, Silverado LD, Suburban, Tahoe, GMC Sierra LD, Sierra HD, Yukon, and Yukon XL vehicles. GM will notify owners and dealers will inspect the ignition lock housing to see if it needs a free replacement. RECALL Subject : Ignition Lock Actuator may Bind Report Receipt Date: DEC 30, 2014 NHTSA Campaign Number: 14V827000 Component(s): ELECTRICAL SYSTEM Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2011-2012 Cadillac Escalade, Escalade ESV, Escalade EXT, Chevrolet Avalanche, Silverado HD, Silverado LD, Suburban, Tahoe, GMC Sierra LD, Sierra HD, Yukon, and Yukon XL vehicles. In the affected vehicles, the ignition lock actuator may bind, making turning the key difficult or causing the ignition to get stuck in the "Start" position. CONSEQUENCE: If stuck in the "Start" position, the ignition may suddenly snap back into the "Accessory" position, causing a loss of engine, steering, and braking power, increasing the risk of a vehicle crash. If the vehicle is in a crash, the air bags may not deploy, increasing the risk of occupant injury. REMEDY: GM will notify owners, and dealers will inspect and replace the ignition lock housing, as necessary, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact GM customer service at 1-800-458-8006 (Cadillac), 1-800-222-1020 (Chevrolet), or 1-800-462-8782 (GMC). GM's number for this recall is 14696 for the original equipment, and 14912 for the service replacement parts.

Final C6 Corvette built in Bowling Green

With all of the attention given to the 2014 Chevrolet Corvette Stingray lately, you could be forgiven for thinking that it's already well along in production, yet tooling up for the new C7 has only just begun. In fact, production of the outgoing C6 generation in Bowling Green, Kentucky just halted on Thursday.
As the C6 has aged, production numbers have predictably ebbed along with demand, but this year, the addition of the 427 and 60th anniversary models resulted in an uptick in vehicles built - this, despite a model year shortened by around 25 percent to accomodate the new model changeover. The final C6 Corvette ever, No. 13,466 built this year, was a white 427 Convertible destined for the General Motors Heritage Center museum. The car's 7.0-liter V8 heart was assembled by Corvette chief engineer Tadge Juechter himself.
In total, Bowling Green pushed out 215,100 C6 Corvettes over nine years. If you're still a C6 fan at heart and are hoping to get a good deal on a phase-out model, step lively - Chevrolet reportedly had about 6,100 unsold units, which Autoweek suggests is good for around five and a half months of supply at the model's current sales rates. Given that demand will likely slacken even further as the C7 draws closer, that should be a big enough stockpile to keep dealers satisfied until 2014 Stingrays begin showing up on their forecourts in December.

NHTSA closes 4-year GM investigation, issues common sense advisory [w/video]

Since January 2011, the National Highway Traffic Safety Administration has been investigating a possible problem with corroding brake lines in General Motors' GMT800-platform models, like the Chevrolet Silverado and Suburban and GMC Sierra, in states with salt on their roads in the winter. However, as opposed to launching a full recall of millions of vehicles, the government is issuing a common-sense safety advisory to all drivers in snowy states to keep their vehicle's undercarriage clean. It even has a video explaining things. "Older-model vehicles, often driven in harsh conditions, are subject to corrosion over long periods of time, and we need owners to be vigilant about ensuring they, their passengers, and others on the roads are safe," said NHTSA Administrator Mark Rosekind in the announcement of the end of the investigation. The agency was clear in its report that "brake line corrosion seen in the GM vehicles was not unique," and the government "has not identified a defect that would initiate a recall order." Instead NHTSA is advising drivers, especially those of vehicles from before 2007, to wash their vehicle's undercarriage in the winter and spring to remove salt or other de-icing chemicals. It also recommends regular checks by a mechanic to make sure everything is in proper order. According to the investigation documents, for just the GMT800 platform models, NHTSA found 3,645 complaints of brake line corrosion, which included allegations of 107 crashes and 40 injuries. The issue was found to be more common in vehicles over 10 years old. GM has released a statement (embedded below) that the company "supports the consumer advisory from NHTSA urging regular maintenance and care of brake lines on older vehicles." NHTSA Closes Investigation into Brake-Line Failures NHTSA 13-15 Thursday, April 9, 2015 Agency issues safety advisory on preventing undercarriage corrosion WASHINGTON – The Department of Transportation's National Highway Traffic Safety Administration (NHTSA) today issued a Safety Advisory and consumer video encouraging owners of model year 2007 and older trucks, SUVs and passenger cars to inspect brake lines and thoroughly wash the underside of their vehicles to remove corrosive salt after the long winter in order to prevent brake-line failures that increase the risk of a crash.