One-owner~non-smoker~local Trade~dealer Maintained~outstanding Condition! on 2040-cars
Sterling, Virginia, United States
Chevrolet Cruze for Sale
2011 chevrolet cruze ltz sedan 4-door 1.4l(US $16,000.00)
2011 chevy cruze ltz rs
2014 chevrolet cruze lt sedan 4-door 1.4l(US $18,700.00)
2014 chevrolet cruze diesel sedan 4-door 2.0l
4dr sdn ltz low miles sedan automatic gasoline 1.4l l4 mpi dohc 16v turb autumn(US $16,995.00)
4dr sdn lt w/1lt chevrolet cruze lt w/1lt, hendrick certified, low miles low mil
Auto Services in Virginia
Whitten Brothers ★★★★★
Volks Home ★★★★★
Unique Auto Repair ★★★★★
Texaco Xpress Lube ★★★★★
Summers Service Ctr ★★★★★
Speller Auto Repair Service ★★★★★
Auto blog
GM reintroduces Tripower name in the worst way possible
Wed, Aug 1 2018The story of General Motors' use of the Tripower moniker begins way back in 1957, when Semon E. "Bunkie" Knudsen, then General Manager of GM's Pontiac division, directed his engineers to inject more performance into his brand's line of V8-powered automobiles. Fuel injection was an option, but hot rodders flocked instead to Tri-Power (marketed way back when with a hyphen), which grafted a trio of two-barrel Rochester carburetors onto a single intake manifold. A legend was born. And that legend was born of performance. At idle and when full power wasn't required, Pontiac's Tri-Power system used just the middle carburetor, which helped make the setup easier to tune. Depending on the year and model, either a vacuum system or a mechanical linkage opened up the two outer carbs, thereby switching from two barrels to six, and allowing the engine to take in more fuel and air. And it was an easy marketing win – six barrels is better than four barrels, right? Because performance! So, when news filtered in that GM has resurrected the Tripower name, those of us who grew up attending classic car shows and wrenching on old Pontiacs did a double-take. And then we all collectively sighed. Turns out that today's Tripower refers to a trio of fuel-saving measures that include cylinder deactivation, active thermal management, and intake valve lift control, according to Automotive News. And, at least for now, it applies to GM's line of fullsize trucks powered by a 2.7-liter turbocharged four-cylinder engine. We're all for saving fuel whenever possible. And we have zero say in how any automaker chooses to market its products and technologies. But, we'll offer our two cents anyway: Relaunching a storied name from the past is fine. Relaunching a storied name from the past while completely overlooking the reasons the name got famous in the first place is only going to irritate the people who remember the name in the first place. Couldn't they just call this new technology package something else? Related Video: News Source: Automotive NewsImage Credit: Getty Green Marketing/Advertising Chevrolet GM Pontiac Automotive History Truck chevrolet silverado
Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]
Thu, Jan 8 2015With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.
Sunday Drive: Spying an automotive future of performance
Sun, May 13 2018I spy, with my little eye ... the future of the automotive world here in the United States. That pretty much sums up this week's Sunday Drive, in which we pull out the most popular stories on Autoblog of the previous week and try to draw some sort of conclusion as to what binds them all together. This week, it's spy shots, starting with one of the biggest and baddest muscle cars the world has ever seen: the Dodge Challenger Hellcat. The Hellish coupe gets a new hood for 2019 with dual scoops, but that's about the only meaningful change for the new model year. No matter. As long as it's packing 700-plus horsepower under those two hood scoops, all will be right with the world. Moving on, we take keep the performance angle but move it from the street to the dirt with a new version of the Chevy Colorado ZR2 that we think is probably called the Bison. We think it'll keep the high-tech suspension bits of the regular ZR2, but add expedition gear that may include a snorkel and a winch. Which, if true, is pretty dang cool. Keeping the truck theme is the 2019 GMC Sierra. There's nothing particularly noteworthy about the trim level in which the truck was spied, and that's what makes this specific example interesting. Base-model trucks almost never get much attention, but they sell in droves to workers who need an honest-to-goodness truck for work or play and don't care about bells, whistles, or massive chrome badges. And finally we have the 2018 Jeep Wrangler, which is on fire on the sales floor right now. But those are all V6-powered Wranglers flying off the showroom floor. Soon, a turbocharged four-cylinder engine option will become available, and now we know that it will return up to 23 miles per gallon in the city and 25 on the highway. That makes it the most fuel efficient Wrangler that Jeep has ever sold. As always, stay tuned to Autoblog this week for all the automotive news that's fit to publish. 2019 Dodge Challenger Hellcat with twin-scoop hood spied with no camouflage Chevy Colorado ZR2 Bison caught testing 2019 GMC Sierra 1500 spied in base trim level 2018 Jeep Wrangler four-cylinder fuel economy revealed Spy Photos Chevrolet Dodge GMC Jeep Truck Coupe SUV Off-Road Vehicles Performance dodge challenger srt hellcat sunday drive