Classic Red Corvette W/targa Top. Body In Perfect Shape And Very Low Miles! on 2040-cars

Auto blog

Jaguar I-Pace vs. Tesla Model 3 and other EVs: How they compare on paper

The 200-mile club of electric vehicles is really growing. The most recent member is the Jaguar I-Pace, the company's first pure EV. It promises luxury, performance, style, and most important, good range. Nearly as recent is the Hyundai Kona EV, and while it doesn't promise luxury or performance like the Jaguar (it's also smaller), it does pack impressive range. With the introduction of both of these electric cars, we thought we would see how they compare against each other, and the other two big names in high-capacity electric cars: the Chevy Bolt EV and the Tesla Model 3. This isn't intended to be a direct, apples-to-apples comparison, as the four are quite different. If anything, they break into two groups: bigger and more luxurious, and smaller and less expensive. Then again, the number of vehicles with this electric range is small and comparisons to EV's with less range wouldn't be too kind to the other guys. If you want to learn more about these EVs, and compare them with other cars, be sure to check out our Car Finder and comparison tools. Horsepower and torque There is one clear winner here, and that's the Jaguar I-Pace. It packs a whopping 394 horsepower and 512 pound-feet of torque. That comes through a pair of electric motors (one at the front, another at the rear) that provide the Jag with all-wheel drive, the only one of these vehicles to offer it (at the moment). Altogether, it allows the I-Pace to have the best 0-60 mph time of 4.5 seconds. At the other end of the spectrum is the Hyundai Kona EV. It's front-drive, like the Bolt EV, and has effectively the same amount of horsepower as the Chevy at 201 horsepower, but its 0-60-mph time is almost a second slower. And the low-range version of the Kona, excluded because it doesn't go more than 200 miles between charges, is slower still. The Tesla Model 3 is the only vehicle with rear-wheel drive, and with a 0-60 mph of 5.1 seconds for the Long Range model, it is still very quick. Range and energy use Frequently, the all-consuming question with electric cars is, "How far can I go on a charge?" And to go the farthest, you need the long-range Tesla Model 3. It can go 310 miles. It has the added advantage of being able to use the network of Tesla Supercharger stations, though they are pay-per-use with the Model 3. Even the lower capacity Model 3, with just 220 miles of range, can use these stations.

GM seatbelt recall affects over 1m Silverados and Sierras

The Basics: General Motors will recall 895,232 examples of the 2014-2015 Chevrolet Silverado and GMC Sierra 1500 pickups in the US. The campaign will also affect the trucks in markets worldwide, and the total number the company will recall is 1,037,982. The Problem: A steel cable connects the seatbelt to the vehicle, but over time repeated bending can cause the part to fatigue and separate. Injuries/Deaths: None reported. The Fix: Dealers will enlarge the side shield opening and install a pusher bracket on the tensioner. Technicians will also replace the entire tensioner assembly if necessary. If You Own One: GM will contact owners about the recall. The company hasn't said when those notifications would begin. More Information: There are still about 3,000 new examples of these older pickups at dealerships. Until mechanics fix the problem, these vehicles are subject to a stop-sale. Similar problems have affected the General's vehicles in the past. In 2015, the company recalled over 400,000 units of the 2011-2012 Chevrolet Malibu for fatiguing cables. It also hit over a million Lambda platform crossovers in 2014. GM Recalling Certain 2014-15 Pickups to Repair Seat Belts DETROIT – GM is voluntarily recalling 895,232 model year 2014-15 Chevrolet Silverado and GMC Sierra 1500 pickups in the United States because the flexible steel cable that connects the seat belt to the vehicle can fatigue and separate over time as a result of the driver repeatedly bending the cable when entering the seat. This issue was discovered through warranty data, and there have been no reports of crashes, injuries or fatalities related to this issue. For trucks in the field, dealers will enlarge the side shield opening, install a pusher bracket on the tensioner, and if necessary, replace the tensioner assembly. The recall in the United States includes a stop-sale of approximately 3,000 new 2014 and 2015 model year pickups still on dealer lots. Dealers will repair the vehicles prior to delivering them to customers. Customers will be notified by General Motors. They also can look up their vehicle identification number (VIN) at either https://vinrcl.safercar.gov/vin/ website or at https://my.gm.com/web/portal/ownercenter to see if their vehicle is part of the recall. GM also will voluntarily recall and repair these models in other countries where they are sold, including Canada, Mexico, and several countries in Latin America and the Middle East.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck