350/300 With Side Pipes, Auto, T-top on 2040-cars

Auto blog

Recharge Wrap-up: Chevy Volt class action suit proposed, Tesla stock could outperform in 2015

A class action suit has been proposed against General Motors for a steering problem in the Chevrolet Volt. The plaintiffs claim that a defect can cause the steering to freeze intermittently, and that General Motors either knows or should have known about the problem. The case, filed in New Jersey, also claims that defective parts are replaced with the same or similar parts, which are also defective. The plaintiffs say that claims for the 100-plus-member class exceed $5 million. Read more at Law360 or at BigClassAction. Tesla Motors stock (TSLA) has risen after weeks of losses. It gained 5.4 percent during the week ending December 19, when it closed at $219.29 per share. Since then, it rose slightly more, closing at $222.26 on December 24. Morgan Stanley lowered its target price on Tesla stock from $320 to $290, predicting lower sales on the upcoming Model III than expected before, but still called Tesla a good long-term investment. Analysts at CNBC predicted Tesla to be the best performing stock of 2015. Read more at ETF Daily News. Oslo- and New York-based architecture firm Snohetta has designed a zero-emissions house that also charges an electric car. The ZEB Pilot House, built in Larvik, Norway, uses a solar panel on the roof to power the house, which also provides enough excess energy to charge an EV. To make the most of energy most efficiently, the house uses smart technology to use as much energy as it can once it's harvested. This means one can turn on appliances like the washing machine remotely while the sun is at the optimum angle in the sky - perhaps during mid-day when the residents are at work. The house also uses organic materials and is designed to save as much energy as possible. Read more at Wired.

Man spent $75 on a truck that lasted 38 years

Absurd as it is, some buyers today are worried about getting their car to last throughout the term of their seven-year car loan. Minnesota resident Bob Sportel has the opposite issue: his Chevrolet truck seemingly won't die. Sportel needed a cheap ride to get to work when he took a job at a farmer's co-op 38 years ago, so he bought a rusty 1957 Chevy pickup for $75 from a farmer; at the time, the 20-year-old truck was almost as old as Bob was. After nearly four decades of daily driving and an estimated 300,000 miles, Sportel is still driving the truck today. Bolts secure a fender, Bondo secures the lights, what looks like a whole roll of duct tape keeps him sitting on the bench seat instead of in it. For a 58-year-old pickup that's never seen a garage or a new coat of paint – but did get its oil changed four times a year – that's not bad; Sportel thinks his repair bill hasn't got above $1,000 for the entire time he's owned the truck. He still has no plans to get rid of it, saying, "It just becomes a part of you." You can watch his story in the video above. News Source: KARE11.com Chevrolet Truck Classics Videos

GM patent reveals new two-stage turbocharger

Modern turbochargers may be some of the best ever made, but performance is something that engineers are always trying to improve. According to GM Inside News, General Motors (GM) is hoping to alleviate some of the negative aspects of a two-stage turbocharger setup with a newly-patented design. The patent, that was filed on May 19, 2016, reveals a clever bypass system that allows the engine, a four-cylinder unit, to optimize both the low-pressure and high-pressure inlets for its respective functions. According to the filing, a conventional two-stage turbocharger setup is engineered to allow both turbines to operate simultaneously at low and mid engine speeds. At high engine speeds, only the low-pressure turbine works. The setup can't isolate either the low or high pressure side, which can impair low-end performance. GM's new two-stage turbocharger setup looks to eliminate this by linking the high-pressure turbo to the exhaust manifold through the high-pressure inlet duct. The low-pressure turbo is attached to the high-pressure turbo by a low-pressure inlet duct, which is linked to a connecting channel. A single actuator that is housed in the exhaust manifold creates a bypass that can opens the high-pressure inlet or close the connecting channel. Depending on what the engine load and speed is, the ECU guides the actuator—a single rotating spindle with discs corresponding to flanges on the high and low pressure sides—to isolate one of the two turbos. Isolating the turbos allow the respective inlets to be engineered for the best possible fluid dynamic performance. The setup should increase performance and decrease lag. There's no word on what car this setup will make an appearance on, but it will most likely be used in premium vehicles before trickling down to the rest of GM's vehicles. Related Video: News Source: GM Inside News, AutoGuide via GM Authority Cadillac Chevrolet GM Technology Sedan turbo patent engine turbocharging