1984 Chevrolet Corvette Base Hatchback 2-door 5.7l on 2040-cars

Auto blog

Next Corvette ZR1 to get 700 horsepower?

Word has it General Motors may offer as much as 700 horsepower in the C7 Corvette ZR1. Motor Trend reports the next Corvette Z06 will continue to rely on its naturally aspirated 7.0-liter V8 engine for thrust, but the lump will deliver substantially more power. How much more? MT says the engine could deliver up to 600 ponies. That's a jump of 95 horsepower over the current Z06, though no figures have been finalized as of yet. Right now, GM is reportedly waiting to see what sort of grunt it can glean from the next ZR1.
The automaker has already made it clear it will resurrect the LT5 name for the new supercharged V8, and if GM is already pulling 600 from the Z06, the big dog ZR1 would theoretically offer 700 horsepower. Either way, the range-topping Corvette will be suitably insulated from its less potent siblings. Stay tuned. We aren't likely to see the Z06 for at least a year, with the ZR1 trailing along at some point there after.

Will Chevy Bolt get Opel badge in Europe?

General Motors' European plug-in vehicle name may go from A to B. That's because the Chevrolet Bolt could be sold under GM's Opel brand across the Pond, Automotive News Europe says, citing people familiar with the process that it declined to identify. The Ampera, the European version of the Volt extended-range plug-in vehicle, is being phased out due to poor sales. While the Ampera won the European Car of the Year in 2012, its sales have trended well below expectations. That the Bolt would be sold as an Opel hints to us that GM expects to distribute the electric vehicle in far smaller numbers than in the US. The Bolt, which was introduced in January in its concept version at the North American Auto Show in Detroit, will have a single-charge range of about 200 miles. GM representatives didn't immediately respond to a request for comment from AutoblogGeen on Friday afternoon. The car will also have a price tag in the US of about $30,000, factoring in federal-government tax incentives. That's if those tax incentives are still around in 2017, when the Bolt is expected to debut stateside. Related Videos: Featured Gallery Chevrolet Bolt EV Concept News Source: Automotive News Europe-sub.req. Green Chevrolet GM Opel Electric Chevrolet Bolt bolt

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck