2005 Chevrolet Colorado Z85 Ls Ext Cab 4wd - Lots Of Options - Nice And Clean!! on 2040-cars

Auto blog

Fullsize GM SUVs have a problem that's making owners sick

Some fullsize SUV owners are getting sick, thanks to a buffeting and vibration problem in 2015 model year examples of the Chevy Tahoe and Suburban, Cadillac Escalade, and GMC Yukon. According to owners' complaints to the National Highway Traffic Safety Administration, the issue can vary from an annoying vibration inside the cabin to an experience so severe that it leads to dizziness and headaches. General Motors is aware of the complaints, but the fix isn't so simple. According to spokesperson Tom Wilkinson to Autoblog, the company "has been tracking this issue for a while." The problem has a fairly low incidence rate, but when it does occur the issue can be "uncomfortable and annoying for owners." There's no precise cause for the issue, Wilkinson claims, and in some cases, simply balancing the tires or changing the door seals can make it go away. However, not all of the fixes are so simple. AutoGuide dug deep into the problem and discovered a GM preliminary information bulletin that advised dealers to remove the headliner and to check the roof's bonds to the bows that go across the vehicle. However, that document included a note that the solution might not entirely eliminate things. According to AutoGuide, adding Dynamat insulation to the roof sometimes helped the problem. A GM spokesperson also told AutoGuide the company fixed the problem at the end of the 2015 model year, and didn't go into any more detail. This roof issue seems linked to some of the worst droning in these SUVs. According to one complaint from a 2015 Suburban owner to NHTSA: "Roof will not remain attached to the roof bows. This causes the buffeting similar to a window being down when all are up. The results span from annoying to painful." A 2015 Yukon owner claims to have another alleged cause for the problem in a NHTSA complaint from February 2015. This person brought their SUV to the dealer seven times over the course of four weeks for vibrations. The dealer replaced the driveshaft, suspension components, and more, but nothing worked. According to an engineer to the service adviser: "In an effort to prevent roll overs, they designed the frame and body mounts too stiff. There are 40 engineers working on issues, they have no solutions that work across the board." Wilkinson told Autoblog that GM is working with customers on an individual basis to rectify things. Since these are newer vehicles, dealers should also fix the problem under warranty.

Why does the Corvette Stingray have so many vents? Here's why

Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.

Cadillac XT4 crossover to be built in Kansas City

Cadillac's upcoming XT4, a crossover we've previously known as the XT3 in a long series of spy shots of heavily camouflaged mules, will be built at General Motors' assembly plant in Kansas City on the same platform as the Chevrolet Malibu, Bloomberg reports, citing people familiar with the plan. That will give Cadillac another entry in the red-hot luxury crossover segment and, GM hopes, help to reverse a sales slump in the U.S. It'll also breath life into the Kansas City plant that makes the slow-selling Malibu, where GM cut a third shift last year, by sharing the assembly line between the crossover and sedan and defraying costs for each vehicle. The XT4 was known most recently as the XT3, with styling cues based on the Escala concept sedan from 2016. It's slightly smaller than the XT5, Cadillac's top-selling vehicle, and will also augment the full-size Escalade in Cadillac's stable of SUVs when it makes its expected debut later this year. Cadillac last week reported its second-highest-ever sales mark with 356,467 vehicles, an increase of 15.5 percent over 2016. But that mark papers over an 8 percent sales decline in the U.S. to 156,440 vehicles. The luxury brand is on a hot streak in China, where sales jumped 50.8 percent last year to 175,489 units.Related Video: Image Credit: Brian Williams Plants/Manufacturing Cadillac Chevrolet GM Crossover sales cadillac xt5 cadillac xt4 cadillac xt3