Find or Sell Used Cars, Trucks, and SUVs in USA

Numbers Matching 1972 Chevy Cheyenne C10 on 2040-cars

Year:1972 Mileage:130000 Color: blue and white /
 Blue
Location:

Fort Smith, Arkansas, United States

Fort Smith, Arkansas, United States
Advertising:
Transmission:turbo 400
Body Type:long bed
Engine:402
Vehicle Title:Clear
Fuel Type:Gasoline
VIN: cce14s161573 Year: 1972
Exterior Color: blue and white
Make: Chevrolet
Interior Color: Blue
Model: Cheyenne
Trim: cheyenne
Cab Type (For Trucks Only): single
Drive Type: 2x4
Mileage: 130,000
Condition: UsedA vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections.Seller Notes:"this is a 41 year old truck, 90% of the parts are original from 1972, could use a total restoration"

 Well here is what we have, a numbers matching 1972 chevy 1/2 ton long bed pick up, has 402 big block that runs well, p/s, p/b, a/c that blows cool, turbo 400 tranny that shifts great, 3.42 gear ratio....now for the good about this truck, I bought it from my EX father inlaw, his dad bought it new in 72, engine was rebuilt 12 years ago but has about 42,000 miles on it, tranny was rebuilt 8 years ago when he bought it, he used it as a farm truck mostly, i just put a new radiator, cap, rotor, plugs, wires, dash, and new window seals on both doors, i do have a new grille that has not been installed yet, replaced heater hoses, lower coolant hose, water pump and thermostat, new power steering pump and hoses, rebuilt carb, has new brakes on the front with turned rotors, new rubber on the fuel lines and new fuel pump...now for the bad-- body has a little rust in both cab corners and rockers, cracked windshield, blower motor only blows on low, radio dont work, has hole in seat, has exhaust leak on right side "header gasket", still has R12 refridgerant, temp gauge don't work and needs restored, trucks like these are rear and getting hard to find with original parts still intact, i set a FAIR reserve,  feel free to come look or drive the truck anytime, have for sale localy so i can end auction at anytime email me with any ??? you might have, don't need to sell it, but not doing me any good just sitting here......good luck-----the new grille is installed and picture has been added  

Auto Services in Arkansas

Weber Automotive Repair ★★★★★

Auto Repair & Service
Address: 5961 Commerce Ct, Little-Rock-Air-Force-Base
Phone: (501) 835-8582

Riverdale Automotive Ltd ★★★★★

Used Car Dealers, Automobile Parts & Supplies
Address: 941 Locust St, Enola
Phone: (501) 205-8622

Pro Care Tire & Auto ★★★★★

Auto Repair & Service, Tire Dealers
Address: 5800 E Highland Dr, Jonesboro
Phone: (870) 275-6253

Mustard Seed Mobile Auto Repair & Towing ★★★★★

Auto Repair & Service, Towing
Address: 2116 Westport Loop, Bigelow
Phone: (501) 301-4878

Larry`s Mobile ★★★★★

Auto Repair & Service, Auto Transmission, Automotive Tune Up Service
Address: 307 E Highway 64, Hartman
Phone: (479) 497-9007

Larry Hice Custom & Collision ★★★★★

Automobile Body Repairing & Painting
Address: 62 N Brooklyn Rd, Ratcliff
Phone: (479) 847-5446

Auto blog

Chevy to resume engine-building program for 2015 Corvette Z06

Thu, Jan 8 2015

One of Chevrolet's most popular and unique customer features is set to return for 2015, as the company has announced that the Engine Build Experience is back. Interested owners will be able to screw together their engines beginning in March. The $5,000 option (which does not include the cost of travel) will give future owners of the 2015 Corvette Z06 the chance to screw together their car's actual 6.2-liter, supercharged V8. Available on each of the Z06's three trims, the Engine Build Experience includes a day at the Performance Build Center, instruction from an engine assembly tech, photographs of the experience and a personalized engine plaque. Once the build process is completed, the engine will (eventually) be fitted under the hood of the customer's personal Z06. "Chevrolet recognizes the passion customers have for Corvette and the Engine Build Experience offers them a truly unique opportunity for hands-on involvement in the creation of the heart of their new car," Corvette product manager Harlan Charles. "It's important for customers to understand their engine won't be installed the day after they built it. It will flow into the scheduling process for vehicle assembly, which depends on a number of logistical variables." Scroll down for the official announcement of the Z06's Engine Build Experience, available below. Exclusive Corvette Engine Build Experience Returns Program renewed for supercharged LT4 engine at new Bowling Green build center 2015-01-07 BOWLING GREEN, Ky. – Chevrolet announced today it is resuming the exclusive Engine Build Experience for Corvette Z06 customers – the only program of its kind for supercar customers. Starting in March 2015, Corvette Z06 customers will be able to assemble the 650-hp supercharged LT4 engine for their cars at the new Performance Build Center inside the Bowling Green Assembly Plant. "Chevrolet recognizes the passion customers have for Corvette and the Engine Build Experience offers them a truly unique opportunity for hands-on involvement in the creation of the heart of their new car," said Harlan Charles, Corvette product manager. "It's a chance to bond with their new car." The Engine Build Experience is selected with order code PBC and is offered on all Z06 trim levels.

Meet the mother-daughter team that's worked on almost every Chevy Volt

Sun, May 11 2014

It's Mother's Day, and we're soft enough we love our mothers enough to share a new video from General Motors with you. In it, we meet Monique Watson (left) and Evetta Osbourne, a mother-daughter team that works at the Detroit-Hamtramck Assembly where GM makes the Chevy Volt (along with all of GM's other plug-in hybrids: the Opel Ampera, Holden Volt and Cadillac ELR). The two work side-by-side and have installed the lithium-ion battery pack on almost all of those vehicles - nearly 80,000 of them - since GM started making the pre-production Volts in 2009. In a prepared statement, Watson said that she likes working next to her mom, day in and day out, and they the two are totally in sync when it comes to putting the 400-pound, 16.5-kWh packs into the vehicle undersides. They two can also share stories throughout the day, and Watson said, "The arrangement has absolutely improved our relationship." Osborne started working at Detroit-Hamtramck in 1999, Watson since 2006. If you're driving a Volt today, you probably have them to thank for doing a bit of the work putting your car together. See a short video of them in action below. It's Always Mother's Day for Detroit-Hamtramck Duo Mother, daughter install lithium-ion battery pack in nearly all GM electric vehicles 2014-05-08 DETROIT – For Detroit resident Evetta Osborne, every day is Mother's Day. That's because she literally works side by side with her daughter, Monique Watson, at General Motors' Detroit-Hamtramck assembly plant. They have installed the lithium-ion battery pack on nearly every Chevrolet Volt, Opel Ampera, Holden Volt, and Cadillac ELR since production began. In fact, apart from vacation days and an occasional sick day, the mother-daughter duo has installed almost every battery pack since the Volt was in pre-production in 2009. The ELR launched earlier this year. All told – including Ampera – that's more than 80,000 electric vehicles. "We're a good team and our relationship is secondary when it comes to performing our jobs – but it's great to work alongside my daughter, said Osborne, a mother of five. Because the battery packs weigh more than 400 pounds each, automatic guided vehicles – robotic carts that use sensors to follow a path through the plant – deliver them just as the vehicle body structures glide into position overhead. The carts then lift the T-shaped packs, and Osborne and Watson guide them into the chassis and secure each one with 24 fasteners.

Weekly Recap: Lamborghini to build SUV

Sat, May 30 2015

Finally, Lamborghini will build a sport utility vehicle. The Italian supercar maker confirmed this week that it will launch a luxury SUV in 2018. It will be built at Lamborghini's soon-to-expand factory in Sant'Agata Bolognese in Italy, and will double the company's current sales volume. Lamborghini did not announce a name for the vehicle or other details, but noted a concept version, the Urus, was displayed at the Beijing motor show in 2012. It will be sold around the world, but it's expected to be a critical offering in the United States, China, and the Middle East. The automaker projects the SUV will sell about 3,000 units per year, and it will be the third product in Lamborghini's portfolio. It currently sells the Huracan and Aventador supercars. "The introduction of a third model line endorses the stable and sustainable growth of the company and signifies for us the beginning of a new era," Lamborghini chief executive Stephan Winkelmann said in a statement. The project is also a boon for Italy, which will get 500 new jobs in the Emilia Romagna region as Lamborghini's factory will nearly double in size. Ian Fletcher, principal analyst for IHS Automotive, said the SUV will position Lamborghini for future growth. "It could well also bring new customers to the brand [who] may find the dramatic styling of Lamborghini products appealing, but find its typical sports cars restrictive," he said. "If it is a success, the SUV could be a catalyst to Lamborghini broadening its portfolio further." OTHER NEWS & NOTES GM invests in Chevy Camaro factory General Motors is investing $175 million to upgrade its factory in Lansing, MI, to build the 2016 Chevy Camaro. The investment will pay for new tooling and equipment. The improvements include three new paint systems and two new robotic framers. GM will add a second shift at the factory to build the Camaro, resulting in 500 jobs. The automaker had dropped the plant to one shift last year amid slow sales for its products, the Cadillac ATS and CTS. GM is spending $5.4 billion over the next three years to upgrade its US facilities. Last week, GM announced plans to spend $439 million to build a new paint shop for the Chevy Corvette. While the Camaro and Corvette plant improvements are intriguing to enthusiasts, GM also confirmed this week that it is investing $1.2 billion in its Fort Wayne (IN) factory that builds trucks.