1971 Chevrolet Chevelle Convertible V8 Auto Alum Heads Pwr Disc Cowl Wheels Look on 2040-cars

Auto blog

GM recalling 15k midsize pickups over leaky brakes

General Motors has announced a recall in coordination with the National Highway Traffic Safety Administration related to the brakes on the 2015 Chevy Colorado and GMC Canyon. In the 14,838 units in the United States estimated to be affected, the front brake calipers may be leaking fluid. Needless to say, that could make them less effective, which could hinder the vehicle's ability to stop in time to avoid a collision. The affected units were all manufactured between January 6 and December 24, 2014. The fix seems simple and straightforward enough, with dealers being instructed to inspect the front brake calipers, and replace them if necessary. See below for all the details from NHTSA. RECALL Subject : Brake Fluid Leak Report Receipt Date: MAY 12, 2015 NHTSA Campaign Number: 15V278000 Component(s): SERVICE BRAKES, HYDRAULIC Potential Number of Units Affected: 14,838 Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2015 Chevrolet Colorado, and GMC Canyon trucks manufactured January 6, 2014, to December 24, 2014. The affected vehicles may experience the front brake calipers leaking brake fluid. This is due to air pockets, an imperfection in the metal caliper body. CONSEQUENCE: If the vehicle experiences a brake fluid leak it can increase the stopping distance, increasing the risk of a vehicle crash. REMEDY: GM will notify owners, and dealers will inspect and replace the front-brake calipers if necessary, free of charge. The recall is expected to begin July 10, 2015. Owners may contact GM customer service at 1-800-222-1020 (Chevrolet), or 1-800-462-8782 (GMC). GM's number for this recall is 14888. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov. Related Video: Featured Gallery 2015 Chevrolet Colorado: First Drive View 38 Photos News Source: National Highway Traffic Safety AdministrationImage Credit: Copyright 2015 Seyth Miersma / AOL Recalls Chevrolet GMC Truck gmc canyon brakes

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Chevy Trax engineer says GMC version possible

The Buick Encore is doing so well and its platform-mate the Chevrolet Trax has such good reviewer vibes going for it already, that a GMC version hasn't been ruled out. During the recent press launch, Automotive News asked lead engineer Al Manzor if the Trax could wear a GMC-branded suit, to which Manzor replied, "I think that is certainly possible." That's a long way from telling us anything about the probability of a GMC version of the Trax, and a legion of questions would need to be answered before it could happen. How would a GMC version be priced to leave room for the $26,465 GMC Terrain but not eat into sales of the $20,995 Trax or the $24,035 Encore? Or would that matter? Could it primarily be considered to encourage a new faction of The Yukon Set at the compact end, GMC buyers being famously committed to the marque? And of course, would there be a Denali version? It'll probably be a long while before we have any kind of answers, but if you want to see it happen, the door to your campaign of persuasion is at least ajar.