1970 Chevrolet Chevelle on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Here's why automakers roll out those Texas-themed pickup trucks

Every year, automakers with a full-size truck link make a big show of the Texas State Fair, usually involving a reveal of a new model. Sometimes they show a whole new truck, and other times a special edition centered on the Lone Star state. While some people might write this off as a quirk of the industry, others might be wondering, "What's the big deal with Texas?" As it turns out, part of the big deal with Texas is big truck sales. According to Dave Sullivan, product analysis manager at AutoPacific, Texas buys more trucks than any other state in the country. It's not a small margin either. Edmunds.com, one in five trucks sold in the US are sold in Texas. The state also accounts for 15 percent of the country's large truck sales, which is more than twice that of California, the second largest truck market in America. Even when you break down sales only in Texas, trucks are a huge piece of the pie - Sullivan says that a quarter of new vehicle sales in Texas are trucks. One in five trucks sold in the US are sold in Texas. But it's not just sales that make truck builders give attention to Texas. As Sullivan explained, "Pickups are life in Texas." Both he and Hugh Milne, marketing and advertising manager for the Chevy Silverado line, said that trucks are key fixtures in Texas society, as both work trucks and luxury vehicles (or Texas Cadillacs as Milne called them). Milne said Texas is so important in the truck market that if you want to be successful in the rest of the country, "you've got to be successful in Texas." As for the State Fair, it has become a prime location for reveals in part because of the importance of the Texas market and because of how big the fair is. Milne also revealed that the State Fair also hosts its own auto show, so it's an ideal venue for a vehicle introduction. So there you have it. Why do truck builders obsess over Texas? It's because Texas obsesses over trucks. When you have one market that loves your product that much, you give it the attention it deserves. Related Video: Image Credit: Donovan Reese via Getty Images Auto News Marketing/Advertising Chevrolet Ford RAM Truck f-150 texas state fair

Chevy Corvette gets Valet Mode with Performance Data Recorder [w/video]

For the 2015-model-year, Chevrolet introduces Valet Mode for the Corvette, an enhancement to the Performance Data Recorder (PDR) already available and to your peace of mind. The PDR already captures 720p HD video with a windshield-mounted camera, records interior audio with a cabin microphone and gathers telemetry data using GPS, saving the data to an SD card in the glovebox. You can then watch your track-day antics with various information overlays on the center console screen.
Valet Mode will let you hit 'Replay' when your car gets pulled up front smelling vaguely of fricasseed clutch. Turned on by entering a four-digit code, it also locks the interior storage spaces and turns off the infotainment system. It can't be turned off until the code is re-entered. There's a press release below with more information as well as a video that explains how it works, with the obligatory dig at the 'Vette's biggest foe.