1968 Chevelle 396 4 Speed Car Mint on 2040-cars

Auto blog

Amelia Island 2013: Chevrolet Corvette Sting Ray from concepts to split windows

While this year marks 60 years of the Chevrolet Corvette, the 2013 Amelia Island Concours d'Elegance focused on one of the coupe's most sought after models, the 1963 Sting Ray. General Motors design boss Ed Welburn was on hand to show off the all-new C7 Corvette, but even the hard-edged styling of the 2014 Stingray couldn't take away from the beautiful 1963 models sitting out on the field.
In addition to the original Sting Ray and the 1959 Sting Ray Concept, some of the other classic 'Vettes included "Big Tank" racecars, an interesting cutaway coupe, a right-hand-drive Z06 and the attention-grabbing 1963 Corvette Rondine by Pininfarina. Another impressive Corvette was the 1964 Corvette XP-819 rear-engine prototype. Owner Mike Yager had the car finished as a driving chassis for this year's show, but promises the car will be back to its original glory in time for next year's event.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

2017 North American Car, Truck, and Utility Vehicle of the Year finalists revealed

The finalists for the 2017 North American Car, Truck, and Utility Vehicle of the Year were announced Tuesday at AutoMobility LA ahead of the 2016 LA Auto Show. Approximately 60 judges, including Autoblog's editor-in-chief Mike Austin, evaluated over 40 vehicles and named three models as the finalists in each category. The award for the Utility Vehicle of the Year is new for 2017 and separates SUVs, crossovers, and minivans from pickup trucks. The finalists are: Car of the Year: Chevrolet Bolt Genesis G90 Volvo S90 Truck of the Year: Ford F-Series Super Duty Honda Ridgeline Nissan Titan Utility Vehicle of the Year Chrysler Pacifica Jaguar F-Pace Mazda CX-9 The winners for the 24th annual NACTOY awards will be named on January 9 at the Detroit Auto Show. Related Video: Chevrolet Chrysler Ford Honda Jaguar Mazda Nissan Truck Crossover Minivan/Van SUV Electric Luxury Sedan north american car of the year NACTOY