1967 Chevelle on 2040-cars

Auto blog

Electric Cadillac Lyriq, Chevy Bolt EUV and more GM electric cars are on the way

GM’s murky and somewhat secretive electric car plan is falling into place, as the company dumped a massive amount of information about whatÂ’s in the pipeline at an event at its Warren, Michigan campus today. New EVs are going to be popping up across the GM brand lineup, with new entries from Chevrolet, Cadillac, GMC and Buick in progress. We also learned some big news about GMÂ’s new Ultium battery tech today, but check out this story for all of those nitty-gritty details. The electric vehicle onslaught will begin with the Cadillac Lyriq, an electric SUV thatÂ’s already been teased out. Naming it the Lyriq is the news today. No explanation for the name was provided, so weÂ’ll have to wait for April to learn more. GM didnÂ’t specifically say if the Lyriq would be launched at the NY Auto Show, but that show (assuming coronavirus doesnÂ’t cancel it) will begin on April 8 this year. Next up in the order of events is the GMC Hummer electric truck that we know will be launching on May 20. This truck will use GMÂ’s modular Ultium battery technology. However, the wait to buy a GMC Hummer will be a long one, as the truck isnÂ’t going to dive into production until fall 2021 at GMÂ’s Detroit-Hamtramck plant. GM revealed that its new modular Ultium batteries can be configured anywhere from a 50 kWh pack to a 200 kWh pack depending on the application. Range is estimated to be about 400 miles on the upper end with the largest battery pack, and GM continues to boast about a 0-60 mph acceleration time of three seconds. Charging estimates for the Ultium battery-equipped Hummer EV were also provided. GM says its truck platform will have 800-volt battery packs and be capable of 350 kW fast-charging. Time estimates werenÂ’t given, but those numbers suggest the truck will be a rapid charger. The Hummer truck on hand, which was the same that previously starred in GMC's Super Bowl spot, showed off removable roof panels that store in the frunk, as well as what appeared to be a version of GMC's Multi-Pro tailgate. It also featured sail panels on the sides, similar to those in front of the bed of the Chevy Avalanche. In addition to the Hummer, expect to see a couple Chevys launching. GM says the refreshed Bolt EV will be launched “in late 2020” with a refreshed interior and what appear to be thicker front seats.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Corvette Stingray designer lists five goals of new exterior shape

Redesigning an icon is a difficult task, especially when you've got a blank sheet of paper in front of you and the all-new C7 Chevrolet Corvette Stingray is intended to be your final objective.
General Motors has released a new short video featuring Kirk Bennion of the Corvette's exterior design team, talking about the challenges of sculpting Chevrolet's new flagship sports car and the five goals the team had to keep in mind as it worked. In the end, Bennion's team had the pleasure of seeing their hard work take center stage as the Corvette captured the world's eyes at the Detroit Auto Show earlier this year.