1966 Chevrolet Chevelle Ss Convertible on 2040-cars

Auto blog

Junkyard Gem: 2003 Chevrolet Tracker

When General Motors created the Geo brand to sell vehicles designed and — in some cases — built by Japanese partners, the first four models were introduced for the 1989 model year: the Metro (Suzuki Cultus), Prizm (Toyota Sprinter), Spectrum (Isuzu Gemini) and Tracker (Suzuki Sidekick). Geo got the axe in 1997, with the Metro, Prizm and Tracker becoming Chevrolets. Of those, the Tracker survived the longest, with U.S.-market sales continuing into 2004. Here's an example of a very late Tracker, found in a North Carolina car graveyard recently. The 1989-1997 first-generation Trackers were based on the Suzuki Sidekick, while the 1998-2004 Trackers had the Suzuki Vitaras (not to be confused with the much grander Grand Vitaras) as their siblings. Production of these trucks for the South American market (as the Chevrolet Vitara) continued in Ecuador all the way through 2014. The Tracker name has also gone onto some versions of the Chevrolet Trax around the world. This one is a base four-door hard top/rear-wheel-drive model, which had an MSRP of $17,330. That's about $29,789 in 2024 dollars. You'll find one in every car. You'll see. The engine is a Suzuki 2.0-liter straight-four rated at 127 horsepower and 134 pound-feet. A five-speed manual was base equipment, but very few American vehicle shoppers wanted three pedals by the middle 2000s. This truck has the Aisin four-speed automatic. We like it loud. It appears that someone associated with this truck graduated from Julius L. Chambers High School last year. In the United States, the Tracker was replaced by the Saturn Vue. If Tracker can handle (unspecified Middle Eastern country), it can survive the jungle back home. Siempre contigo.

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Why does the Corvette Stingray have so many vents? Here's why

Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.