Find or Sell Used Cars, Trucks, and SUVs in USA

1968 Chevy Caprice on 2040-cars

Year:1968 Mileage:39000
Location:

Montgomery, Alabama, United States

Montgomery, Alabama, United States

 A nice 1968 Chevy Caprice  believed  to be only 39000 miles on this car big block  396 v8,auto,green on green,new stickers, new black vinyl top,still as the factory interior,new paint as some trash in it,18 in boss wheels,good tires,new chrome,still have factory radio,as aftermarket radio right now,drum brakes all the way around,fuel gauge does not work,little stains on rear seat but in good shape,new carpet,dash pad in good shape,chrome is great shape,roll down windows and air still on car needs valve.. We detailed engine  and painted it took valve covers off it was very clean no oil slush.  Any question please call 334-235-4517 bill of sale

Auto Services in Alabama

Worldpac ★★★★★

Automobile Parts & Supplies
Address: 260 Oxmoor Pl, Cahaba-Heights
Phone: (205) 621-8828

Wayne`s Auto Service ★★★★★

Auto Repair & Service
Address: 2316 Highway 78, Sumiton
Phone: (205) 648-3003

Waites Tire and Service Center ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Wheel Alignment-Frame & Axle Servicing-Automotive
Address: 310 Battle St E, Talladega
Phone: (256) 362-6632

Vinnies Auto Repair ★★★★★

Auto Repair & Service
Address: 26030 Capital Dr., Loxley
Phone: (251) 213-8257

Vestavia Auto Service ★★★★★

Auto Repair & Service, Automobile Repairing & Service-Equipment & Supplies, Brake Repair
Address: 2000 Buena Vista Dr, Vestavia
Phone: (205) 979-3661

Trammell Mike Body Shop ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting
Address: 2121 2nd Ave S, Birmingham
Phone: (205) 323-5515

Auto blog

Motor Trend puts Chevy Camaro Z28 and Porsche 911 GT3 Head 2 Head

Mon, Dec 29 2014

Motor Trend admits, "This is an unfair comparison." But that doesn't make it any less fun to watch when they pit a Camaro Z/28 against the Porsche 911 GT3. The former has a 7.0-liter V8 with 505 horsepower and 481 pound-feet of torque shifted through a six-speed manual. The latter has a 3.8-liter flat-six with 475 hp and 324 lb-ft shifted through a seven-speed dual-clutch transmission. Yet those are only the little disparities – the big disparities are mass and money: the Camaro weighs 3,882 pounds and costs $76,150 as-tested, the Porsche weighs 3,267 pounds and costs $145,785. But they're both about hardcore performance, so MT takes them out on the street, to the drag strip, to the parking lot for figure eights and a skidpad test, and finally to Big Willow for Randy Pobst to give his professional assessment. Remember when a lotta people spent a lotta time debating Pirates vs. Ninjas? This is like that, only it's the "haul-ass good-time car" vs. the "track surgeon." Enjoy the debate in the video.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

Thu, Dec 7 2017

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Autoblog Podcast #389

Wed, Jul 16 2014

Episode #389 of the Autoblog podcast is here, and this week, Dan Roth, Chris Paukert, and Mark Pereira from Autoblog Canada talk about Johan deNysschen's move to Cadillac, rumors of more BMW nomenclature changes, a second generation for the Subaru BRZ, and cars from 2004 that we miss. We start with what's in the garage and finish up with some of your questions, and for those of you who hung with us live on our UStream channel, thanks for taking the time. Check out the new rundown below with times for topics, and you can follow along down below with our Q&A. Thanks for listening! Autoblog Podcast #389: The video meant to be presented here is no longer available. Sorry for the inconvenience. Topics: Johan de Nysschen moves to Cadillac BMW model designations changing even more Subaru BRZ getting second generation Cars We Miss In the Autoblog Garage: 2014 Ducati 899 Panigale 2015 Hyundai Sonata 2015 Volkswagen GTI 2015 Chevrolet Silverato 2500 Diesel Hosts: Dan Roth, Chris Paukert, Mark Pereira Runtime: 01:59:10 Rundown: Intro and Garage - 00:00 Johan deNysschen - 36:12 BMW Nomenclature - 53:58 BRZ - 56:27 Cars We Miss - 01:05:07 Q&A - 01:30:09 Get the podcast: [UStream] Listen live on Mondays at 10 PM Eastern at UStream [iTunes] Subscribe to the Autoblog Podcast in iTunes [RSS] Add the Autoblog Podcast feed to your RSS aggregator [MP3] Download the MP3 directly Feedback: Email: Podcast at Autoblog dot com Review the show in iTunes Auto News Hirings/Firings/Layoffs Podcasts BMW Cadillac Chevrolet Hyundai Subaru Volkswagen