Way Below Msrp & Invoice New Navi Camera Sunroof 2013 2014 Nav Automatic Ss on 2040-cars

Auto blog

GM isn't liable for punitive damages in ignition switch cases

NEW YORK — A federal appeals court said General Motors is not liable for punitive damages over accidents that occurred after its 2009 bankruptcy and involved vehicles it produced earlier, including vehicles with faulty ignition switches. The 2nd U.S. Circuit Court of Appeals in Manhattan said on Tuesday that the automaker did not agree to contractually assume liability for punitive damages as part of its federally-backed Chapter 11 reorganization. GM filed for bankruptcy in June 2009, and its best assets were transferred to a new Detroit-based company with the same name. The other assets and many liabilities stayed with "Old GM," which is also known as Motors Liquidation Co. Tuesday's 3-0 decision may help GM reduce its ultimate exposure in nationwide litigation over defective ignition switches in several Chevrolet, Pontiac and Saturn models. It is also a defeat for drivers involved in post-bankruptcy accidents, including those who collided with older GM vehicles driven by others, as well as their law firms. The ignition switch defect could cause engine stalls and keep airbags from deploying, and has been linked to 124 deaths. A lawyer for the drivers and their law firms did not immediately respond to requests for comment. GM had no comment. Circuit Judge Dennis Jacobs said GM's agreement to acquire assets "free and clear" of most liabilities excused it from punitive damages claims for Old GM's conduct. He also noted that the judge who oversaw the bankruptcy concluded that the new company could not be liable for claims that the "deeply insolvent" Old GM would never have paid. The decision upheld a May 2018 ruling by U.S. District Judge Jesse Furman in Manhattan, who oversees the ignition switch litigation. Drivers have sought a variety of damages in that litigation, including for declining resale values. GM has recalled more than 2.6 million vehicles since 2014 over ignition switch problems. It has also paid more than $2.6 billion in related penalties and settlements, including $900 million to settle a U.S. Department of Justice criminal case. The case is In re: Motors Liquidation Co, 2nd U.S. Circuit Court of Appeals, No. 18-1940. Government/Legal Chevrolet Pontiac Saturn Safety gm ignition switch

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

First 2015 Chevy Corvette Z06s en route to owners [w/video]

Pretty much right on schedule, Chevrolet has begun shipping the very first customer examples of its 650-horsepower, supercharged Corvette Z06. In fact, according to General Motors, the earliest Z06s could be in customer hands by the end of this week. "It has been an incredible opportunity to work on Chevy's most capable model," said Jeff Lamarche, manager of Chevy's Bowling Green Assembly plant. "It truly is an amazing car, and we're thrilled to get them into the hands of our eager customers." Prices for the Z06 start at $78,995 for the hardtop model, while the first-ever Z06 Convertible kicks off at $83,995. Take a look below for the official press release from Chevrolet, and while you're down there, we've slipped in a new video of Corvette Racing's Tommy Milner taking a hot lap of Road Atlanta in a Z06, complete with some Performance Data Recorder footage. First 2015 Corvette Z06s on Their Way to Customers Most capable model in Chevrolet's history now shipping from Bowling Green BOWLING GREEN, Ky. – Chevrolet is now shipping the all-new 2015 Corvette Z06 coupe from Bowling Green Assembly and some early customers could receive the much-anticipated supercar later this week. "It has been an incredible opportunity to work on Chevy's most capable model," said Jeff Lamarche, plant manager of General Motors' Bowling Green Assembly plant, "It truly is an amazing car, and we're thrilled to get them into the hands of our eager customers." The new Corvette Z06 offers the most choice for customers in the model's history. It is the first Z06 to offer an available eight-speed paddle-shift automatic transmission and, thanks to a stronger aluminum frame, a removable roof panel. In addition, it is the first time since 1963 that the Z06 is available as a convertible – which will arrive in early 2015. The new LT4 supercharged 6.2L V-8 engine is SAE-certified at 650 horsepower (485 kW) at 6,400 rpm and 650 lb-ft of torque (881 Nm) at 3,600 rpm – making the 2015 Corvette Z06 the most powerful production car ever from General Motors and one of the most powerful production cars available in the United States. To balance performance and efficiency, the LT4 leverages a trio of advanced technologies – direct injection, Active Fuel Management (cylinder deactivation) and continuously variable valve timing –with a new, more efficient supercharger. The LT4 helps make the Corvette Z06 the most capable car in the brand's history.