Frame Up Restored Camaro Z/28 302 Cross-ram 4 Speed on 2040-cars

Auto blog

GM follows up Lambda CUV stop-sale with tire recall

In late January, General Motors announced a stop-sale for about 6,281 examples of the 2015 Chevrolet Traverse, GMC Acadia and Buick Enclave because of the possibility for the treads cracking on their 18-inch Goodyear Fortera HL tires. At the time, GM said that this would also eventually lead to a safety campaign to repair the problem, and the National Highway Traffic Safety Administration has just published those details. GM's recall covers 5,876 of the three Lambda platform crossovers to replace their tires. According to NHTSA, if the treads crack, there could be a loss of pressure and possible failure. Goodyear already announced its own recall of the tires after internal testing found small tread cracks. The company did not believe this was safety issue, but the problem did put the rubber out of compliance with federal laws. The business's safety campaign covered an estimated 48,512 tires. Of those, around 32,000 were reportedly made for GM to either be fitted to vehicles or sold as replacements. The remainder went to the aftermarket. Goodyear's portion of the recall is expected to begin around February 20. RECALL Subject : Tire Tread Cracking/FMVSS 110 Report Receipt Date: JAN 28, 2015 NHTSA Campaign Number: 15V044000 Component(s): TIRES Potential Number of Units Affected: 5,876 All Products Associated with this Recall Vehicle Make Model Model Year(s) BUICK ENCLAVE 2015 CHEVROLET TRAVERSE 2015 GMC ACADIA 2015 Details Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2015 Buick Enclave vehicles manufactured December 9, 2014, to January 14, 2015, 2015 Chevrolet Traverse vehicles manufactured December 9, 2014, to January 20, 2015, and 2015 GMC Acadia vehicles manufactured December 9, 2014, to January 16, 2015, and all equipped with Goodyear P255/65R18 Fortera HL tires. These vehicles are equipped with tires that may experience tread cracking. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) No. 110, "Tire Selection and Rims and Motor Home/Recreation Vehicle Trailer Load Carrying Capacity Information for Motor Vehicles with a GVWR of 4,536 kilograms (10,000 pounds) or Less." CONSEQUENCE: If the tire treads crack, a loss of tire pressure and possible tire failure may result, increasing the risk of a crash. REMEDY: GM will notify owners, and dealers will replace the tires that were manufactured within a specific date range, free of charge.

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Just the right Camaro can change your life

Not many people can say that their car directly motivated them into a career, but that's exactly the case for Adam Martin and his 1968 Chevrolet Camaro that he calls Lucy. Martin bought the pony car in primer when he was just 16, and it helped foster his profession in restoring classic cars. Beyond just being a very cool ride for a teenager, every change to Lucy was an opportunity to hone a new automotive skill for Martin. Whether figuring out how to paint a car or building the 454-cubic-inch (7.4-liter) big block V8, the Camaro offered a platform for experimentation. This latest episode of Petrolicious gets personal about the bond between man and machine for this 18-year ongoing project. And even if the story doesn't immediately grab you, Lucy has a great voice and can do a mean burnout. News Source: Petrolicious via YouTube Chevrolet Maintenance Ownership Coupe Performance Classics Videos petrolicious