Find or Sell Used Cars, Trucks, and SUVs in USA

2011 Chevy Camaro Lt Auto 19'' Wheels Park Assist 24k!! Texas Direct Auto on 2040-cars

US $21,780.00
Year:2011 Mileage:24526 Color: Mirrors
Location:

Stafford, Texas, United States

Stafford, Texas, United States
Advertising:

Auto Services in Texas

Whatley Motors ★★★★★

Used Car Dealers, Wholesale Used Car Dealers
Address: 409 Scott Ave, Sheppard-Afb
Phone: (940) 723-8991

Westside Chevrolet ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 23001 Katy Fwy, Barker
Phone: (281) 392-3200

Westpark Auto ★★★★★

Auto Repair & Service
Address: 4045 Tanglewilde St, West-University-Place
Phone: (281) 320-1185

WE BUY CARS ★★★★★

Used Car Dealers, Financial Services, Loans
Address: 2306 E Berry St, Aledo
Phone: (817) 535-1111

Waco Hyundai ★★★★★

New Car Dealers, Used Car Dealers
Address: 1501 W Loop 340, Bruceville
Phone: (254) 420-2366

Victorymotorcars ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 5829 Beverly Hill St, Missouri-City
Phone: (713) 783-6555

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

Thu, Dec 7 2017

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Question of the Day: Worst year of the Malaise Era?

Thu, Jun 23 2016

The Malaise Era for cars in the United States spanned the 1973 through 1983 model years, and featured such abominations as a Corvette with just 205 horsepower (from the optional engine!) and MGBs with suspensions jacked way up to meet new headlight-height requirements. There were many low points throughout this gloomy period, of course. The horrifyingly low power and fuel-economy numbers for big V8s during the middle years of the Malaise Era make a strong case for 1974 or 1975— the years of Nixon's resignation and the Fall of Saigon, respectively— as the most Malaisey years. But then the GM-pummeling debacles of the Chevy Citation and Cadillac Cimarron could make an early-1980s year the low point. 1979, the year of the ignominious Chrysler bailout? You choose! Related Video:

Are you the 2014 Corvette Grand Sport?

Thu, 21 Feb 2013

When are stripes more than just stripes? Follow up question: Is the product development team at Chevrolet really cocky enough to hide the next C7 Corvette variant in plain sight? This very recently spotted, and ostensibly obscured C7 asks a lot more questions than it answers, but there's at least some evidence to support that it might be the next Corvette Grand Sport.
The first and most obvious tip-off that something is up with this 'Vette revolves around those silver stripes. Obviously the stripes themselves don't necessarily denote a new model. However, when Chevy recently launched its "colorizer" website for the Stingray, there was no provision made for racing stripes - solid colors only.
Grand Sport exhibit number two is actually an incriminating lack of badges. The production Corvettes we've seen to date have all carried Stingray badges on their fenders, just behind the vent. The car seen in these images has no such badges, which is an intriguing omission on an car that looks like a production-spec vehicle otherwise.