1992 Chevrolet 454 Ss Silverado Pick Up Truck on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Ford Police Interceptors dominate Michigan State Police testing

Once again, Ford Motor Company builds the fastest police vehicles. The Blue Oval touted the news in an official release following Michigan State Police and Los Angeles County Sheriff's Department testing. Ford did very well. Except for one acceleration metric – zero to 10 miles per hour – the Blue Oval's Taurus and Explorer-based cop cars were the quickest, with particular praise coming for the EcoBoost-powered models, which bested Chevrolet and Dodge's V8-powered variants. Dearborn's products also posted the fastest average times around MSP's vehicle dynamics course. But it wasn't all positive for Ford. The only four-cylinder in the contest, the 2.0-liter, EcoBoost Ford SSP Sedan, had both the lowest top speed, 120 mph, and the slowest acceleration figures. It was also the slowest in track testing. Ford's products also failed to match the braking and top speeds of its rivals from Detroit and Auburn Hills – the rear-drive Charger Pursuit posted the best braking stats of the entire test, while the V8-powered Chevrolet Caprice hit the highest top speed, at 155 mph. Ford did score a top speed award, among SUVs, but at 132 mph, the naturally aspirated Police Interceptor Utility had to share its award with the equally fast, rear-drive Chevrolet Tahoe. The LA County Sheriff's timing isn't publicly available, but according to Ford, the EcoBoost-powered police cars put on a similarly impressive show for cops on the West Coast. We've assembled a spreadsheet on Google Docs that offers an easy to browse comparison of the different stats assembled by the Michigan State Police, and divided the vehicles between standard V6-powered sedans, high-performance sedans (EcoBoost and V8 models), and SUVs. You can check it out here. Related Video:

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.