1968 Chevy C10 Short Bed on 2040-cars

Auto blog

1983 Motorweek showdown pits Porsche 928S vs. Chevy Camaro Z28

Last month, Motor Trend threw the Camaro Z/28 and Porsche 911 GT3 into the bear pit and let them fight it out. Way back in 1983, MotorWeek had the same idea, comparing the Camaro Z/28 to the Porsche 928S. At the time, the Camaro was America's best selling sports coupe, the 928S was Porsche's top-of-the-line model that also had the highest top speed of any car sold here. And the price differential was even more stark then: $13,600 for the Camaro, $45,000 for the Porsche. That put the Z/28's cast-iron, 5.0-liter V8 with 190 horsepower and 240 pound-feet of torque against the all-aluminum 4.7-liter V8 with 234 hp and 263 lb-ft in the 928S. Even with that and the Camaro being 14 inches longer than the Porsche, the American was a surprising 40 pounds lighter than the German. The show took them to Summit Point Raceway in West Virginia to see how close a relative performance bargain could hang with a the German GT. Both had five-speed manual transmissions, but the high-speed corners and tight sections of Summit Point would test other handling variables, including the "bone-rattling" Camaro's solid rear axle and disc and drum brake setup vis-a-vis the four-wheel disc brakes and independent suspension on the "firm-but-smooth" Porsche. Paradoxically, the larger disparity 22 years ago resulted in a closer result. Check out the video to see how the Summit was won. News Source: MotorWeek via YouTube Chevrolet Porsche Coupe Luxury Performance Classics Videos chevy camaro z28 porsche 928 retro review

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

How long will the 'golden age' of performance last?

High-powered sports and luxury cars were everywhere at the New York Auto Show, prompting the obvious question for enthusiasts: How long will this golden age of performance last? Industry leaders have some time before regulations elevate the Corporate Average Fuel Economy level in 2025. Even then, they expect cars rippling with power to survive in some form. "Is it the end of an era," I don't think so," said Ola Kallenius, Daimler AG board member for Mercedes-Benz cars marketing and sales. "That performance element of individual mobility I don't think will ever go away." Kallenius, who oversaw the company's AMG division from 2010-2013, expects it to continue to grow. Last year, AMG sold a record 68,875 units around the world, an increase of 44.6 percent over 2014, with strong growth in the US, China, and Germany. Still, there's always the potential for gas to spike, and pending fuel economy regulations are looming. That could lead AMG to add electrification to its products, Kallenius said, pointing to the electric SLS as a test case. Chevy is also thinking ahead, said Al Oppenheiser, chief engineer of the Camaro. He wouldn't bite when asked about electrification for the Camaro (he did say "never say never"), but admitted in 2025 "it's going to be pretty tough to sell V8s." For now, things are rosy for muscle cars, and Chevy confidently showcased the 640-hp Camaro ZL1 in coupe and convertible form in New York. "I think that this is truly the golden age of performance," Oppenheiser said. It's hard to disagree. News & Analysis News: The 2017 Mazda MX-5 Miata RF was a show-stopper in New York. Analysis: There was a palpable energy when this RF — for Retractable Fastback — was revealed the night before the show at a trendy off-site venue near the Hudson River. Even as a parade of SUVs and flashy luxury cars rolled out the rest of the week, the Miata remained a hot topic. The Retractable Fastback is really a clever targa top, with part of the roof stowing behind the seats, adding about 100 pounds compared to the standard convertible. It makes the car more practical and arguably more attractive. The RF continues Mazda's tradition of selling the Miata with a hardtop variant. The first and second generations offered a detachable one, and a power retractable hardtop (a $1,700 option) was available on third-gen models. Judging by its reception in New York, the RF could prove to be even more popular than its predecessors.