1962 Chevrolet C-10 Stepside on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Next Chevy Volt will be 2016 model and ride on new chassis

What do we know about the 2016 Chevy Volt? Well, for now, all we can do is try to put the puzzle together without the box. Thankfully, a new batch of pieces has arrived from a new report in Edmunds, which says that the 2016 model year will introduce the second generation of a car that hasn't been dramatically updated since it went on sale in 2010. The new Volt is getting an "evolutionary styling change" and will ride on a new front-drive platform that has been developed by General Motors. GM's Kevin Kelly told AutoblogGreen that he has "no comment on future products," but he did acknowledge that Chevrolet is working on a second-generation Volt, "but I can't say anything about timing." Everybody already knew that a next-gen Volt is coming, so that's not a surprise. What we don't know is any real concrete information on the car itself. The few tidbits of information we do have help define the outlines of the next version of Chevy's halo car, but they're not confirmed yet. For the record, they range from the eye-raising (a $10,000 price drop) to the logical (20 percent more electric range). We can't see the whole picture yet, but the pieces do point to the 2016 Volt, which would be released next year sometime, being a much bigger deal than the last update, when the Volt's range was increased by three electric miles thanks to a battery capacity increase of 16 kWh to 16.5.

GM is the latest automaker accused of diesel emissions cheating

Volkswagen and Ram need to make room on the diesel-emissions bench for General Motors. America's largest automaker was accused in a lawsuit on Thursday of rigging hundreds of thousands of diesel trucks with at least three so-called defeat devices to ensure that the trucks would meet federal and state emission standards, even if they generated more pollution in real-world driving. According to the complaint, on-road emissions testing conducted for the plaintiffs found that Duramax-equipped trucks produced NOx pollutants, comprised of nitrogen and oxygen atoms, two to five times higher than legally permitted, and "many times" higher than their gasoline counterparts. The proposed class-action lawsuit was filed in federal court in Detroit on behalf of people who own or lease more than 705,000 Chevrolet Silverado and GMC Sierra pickup trucks fitted with "Duramax" engines from 2011 to 2016 model years. The lawsuit seeks remedies including possible refunds or restitution for lost vehicle value, plus punitive damages. It adds to legal problems for Detroit-based GM, which has already paid about $2.5 billion in penalties and settlements over faulty ignition switches linked to 124 deaths. GM joins at least five automakers whose diesel emissions have been scrutinized by regulators or consumers. They include VW, which has admitted to cheating; Mercedes-Benz parent Daimler; Fiat Chrysler Automobiles, Peugeot and Renault. GM spokesman Dan Flores called the claims "baseless," and said the trucks comply with US Environmental Protection Agency emissions standards and California's own tough standards. Shares of GM were down 69 cents, or 2.1 percent, at $32.50 in afternoon trading, after earlier falling to $31.93. The GM lawsuit was filed by several law firms, including Hagens Berman Sobol Shapiro, which helped reach multibillion-dollar settlements with VW on behalf of drivers and dealers. The case is Fenner et al v General Motors LLC et al, US District Court, Eastern District of Michigan, No. 17-11661. The named plaintiffs are Andrei Fenner of Mountain View, California and Joshua Herman of Sulphur, Louisiana. They said they would not have bought their respective 2011 Sierra and 2016 Silverado trucks, or would have paid less for them, had they known about the alleged rigging. Joseph Spak, an RBC Capital Markets analyst, in a research report said "negative publicity" from the lawsuit could drive buyers to trucks from Ford or even Fiat Chrysler's Ram.