Awesome 1989 Chevrolet Blazer Silverado Sport Utility 2-door 350 Motor/ 700r4 on 2040-cars

Auto blog

Suzuki recalls 2 million cars globally

Suzuki is recalling two million vehicles across the globe, including a number of Chevrolet Cruze sedans that it builds for General Motors, because the ignition switches may begin to smoke. None of the Cruzes being recalled were sold in the US, though. This recall is limited to the Japanese, European and Australian markets. In Suzuki's home market, 1,873,000 vehicles are being recalled, including the Cruze and a number kei cars built for Mazda (the Carol and AZ-Wagon), as well as the automaker's own Alto, Wagon R and Swift. Affected vehicles were built between 1998 and 2009. The remaining 133,000 vehicles include Cruzes and other Suzuki products sold in Europe and Australia. There have been no reports of injuries or accidents due to the 67 reported incidents, all of which come from the Japanese market, a Suzuki spokesperson told Automotive News. Related Video:

GM recalls select Chevy Cruze, Sonic and Buick Verano models over airbag issue

General Motors is recalling certain 2012 Buick Verano, Chevrolet Cruze and Sonic models due to a defect in the driver's airbag system. According to the National Highway Traffic Safety Administration, the airbag has a shorting bar which may contact two internal terminals. If that happens during a crash, the supplemental restraint may not deploy, increasing the risk of driver injury. The recall includes a total of 2,949 units.
GM will contact owners and replace the steering wheel airbag coil at no cost. At this point, it's unclear when the recall will begin, though owners may contact the automaker at 1-800-521-7300 for more information. You may also take a closer look at the full NHTSA notice below.

Why does the Corvette Stingray have so many vents? Here's why

Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.