95 Blazer Red 148k Miles Two Owners on 2040-cars

Auto blog

2020 Chevy Silverado, GMC Sierra recalled due to faulty brake component

General Motors is recalling 2020 Chevrolet Silverado 1500 and GMC Sierra 1500 pickups to fix a defect in the trucks' brake system. Certain Silverado and Sierra pickups were produced with brake-caliper bolts that were not heat-treated. Without heat-treating, the bolts are weaker than they should be, and there is a risk that they could fail, which would affect the trucks' braking performance, possibly leading to a crash. In total, 20,352 vehicles are affected. Owners of affected trucks will be contacted by GM. Dealers will inspect the bolts and replace those that are defective. Related Video:      

GM recalls 638,000 U.S. SUVs, trucks for unintended braking

WASHINGTON — General Motors is recalling 638,000 U.S. sport utility vehicles and pickup trucks because a wheel-speed sensor could fail and cause unintended braking, it said Thursday. The recall covers 2015-2020 Chevrolet Suburban, Tahoe, and Yukon and 2014-2018 Chevrolet Silverado 1500 and GMC Sierra 1500 vehicles equipped with a 5.3-liter engine, a 3.08-ratio rear axle and four-wheel drive. The sensor failure could result in unintended activation of the driveline protection system, and cause unintended braking of the wheel on the opposite side of the failed sensor. That could cause the vehicle to pull to one side unexpectedly, increasing the risk of a crash, the Detroit automaker said. GM said it was not aware of any crashes relating to the issue but found 150 field claims alleging the condition caused unintended braking or lateral vehicle motion. A GM dealer in May submitted a warranty report relating to the issue in a 2018 GMC Yukon, and two days later, a GM brand quality manager submitted the report to GMÂ’s Speak Up For Safety program that tracks potential safety issues, which prompted a GM investigation and testing. Recalls Chevrolet GM GMC Truck SUV

'Killing a Duramax' Gale Banks YouTube series methodically tunes a diesel to death

Learning or perfecting a skill by watching YouTube videos is known as attending YouTube University. GM Authority picked up on one of the video site's more fascinating courses, hosted by Gale Banks; in a fair world, he should be referred to as Professor Banks when it comes to diesel engines and truck tuning. A few months after GM introduced the updated L5P 6.6-liter Duramax diesel V8 in the 2020 Chevrolet Silverado HD and GMC Sierra HD that ships with 454 horsepower and 910 pound-feet of torque, Banks decided he wanted to methodically tune the engine to death. The purpose of the resulting series, called "Killing a Duramax," is to push more power out of the engine in order to discover which parts break and when — or, as Banks puts it, force-feed the Duramax "until the crank hits the street and the heads hit the hood." With that knowledge, Banks can figure out all the weak points on his way to building what he calls a "Superturbo," that being a supercharged, twin-turbo race engine with more than 1,000 hp. What makes the series fascinating is Banks' knowledge, paired with the company's comprehensive iDash engine monitoring system that keeps tabs on a glut of parameters every step of the way. So for instance, you get Banks explaining the differences between inches of mercury and barometric pressure, how those are different from the water content of the air measured in grains, then showing those readouts on the iDash, then explaining in detail how they affect the air density in the Duramax system. The stock Borg-Warner variable turbo gets a lot of airtime — Banks accuses it of being "out to lunch" because he feels it's the weakest link on the engine. That turns into a turbo teardown and a deep explanation of performance pitfalls, such as when air pressure on the turbine begins to diverge from the boost pressure coming from the compressor. Banks says he can keep close tabs on where power's coming from, because the iDash monitors the horsepower contribution provided by the ambient air, the turbo, and the intercooler separately. The major changes so far are a stouter Precision 7675 turbo and TurboSmart wastegate (episode 5), a twin intake (episode 6), a custom liquid-cooled intercooler from a marine engine, a new GM oil cooler and synthetic oil (episode 10), and new injectors (episode 11).