2015 Chevrolet Wt on 2040-cars

Auto blog

Ford F-150, Chevy Silverado, Toyota Tundra flunk IIHS headlight test

The Insurance Institute for Highway Safety put pickup truck headlights to the test and found that the majority of them were equipped with subpar units. The 2017 Honda Ridgeline was the only truck to earn a rating of "good." The large pickup truck test was comprised of the: 2016 to 2017 GMC Sierra, 2017 Nissan Titan, 2016 Ram 1500, 2016 to 2017 Chevrolet Silverado, 2016 to 2017 Ford F-150, and 2016 to 2017 Toyota Tundra. The Sierra's headlights earned a rating of "acceptable," the headlights found on the Titan and Ram 1500 were found to be "marginal," and the ones on the Silverado, F-150, and Tundra were rated as "poor." IIHS claims the F-150 was the most disappointing out of the large pickup trucks as both its halogen and optional LED headlights failed to provide adequate visibility during testing. The Ridgeline (which earned a "good rating"), is usually considered a midsize or small truck, though IIHS included it in the field of large pickups. The headlights on the 2016 Chevrolet Colorado, 2016 GMC Canyon, 2016 Nissan Frontier, and 2016 to 2017 Toyota Tacoma, which made up the small pickup truck group, all earned a rating of "poor." The IIHS claimed the Colorado had the worst headlights of any truck that was tested, as the base vehicle's units were only able to illuminate up to 123 feet in front of the car. The Ridgeline's headlights, for reference, were able to illuminate up to 358 feet in front of the vehicle. To conduct its test, the IIHS utilizes a special tool to measure how far light is projected out of the headlights in different driving situations. The trucks' headlights were tested in a straight line and in corners, while vehicles with high-beam assist were given extra praise. The headlights on the pickup trucks also mimic the testing that was done on small SUVs and cars earlier this year. Next year, automakers will need to fit their vehicles with headlights that earn a rating of either good or acceptable to earn the IIHS Top Safety Pick+. Related Video:

GM recalls Chevy Express, GMC Savana over rollaway concern

The National Highway Traffic Safety Administration has issued a recall notice for a small number of General Motors fullsize vans due to possible rollaway concerns. On certain 2013 Chevrolet Express and 2013 GMC Savana models, it is possible to remove the key from the ignition without the shifter being in park.
Only 980 total units are being affected by this recall, and GM is fixing the issue by replacing the ignition cylinder and associated keys. Affected Chevy vans were built during most of November and December while its GMC counterpart was only built for a week in November. The recall goes into effect on January 23, and to find out if your vehicle applies to the recall, the GM and NHTSA contact numbers can be found on the official recall notice, which is posted below.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck