1956 Chevy Belair 2dr. Hardtop on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

GM recalls 200k Hummer H3s for fire risk

An issue with fires erupting in some Hummers has prompted General Motors and the National Highway Traffic Safety Administration to issue a recall for nearly 200,000 vehicles around the world. The bulk of them are in the United States. According to the first statement (below) obtained by Autoblog from GM, the issue stems from the HVAC system in Hummer H3 models. The connector module for the blower motor has, in certain cases, overheated, melted the surrounding plastic, and started a fire. 42 such cases have been reported, including three instances of occupants citing minor burns. GM confirms that two of those three cases lead to the vehicle being destroyed in the fire, but states that no crashes or fatalities have resulted. The issue affects 196,379 examples of the 2006-10 H3 wagon and the 2009-10 H3T pickup, with 164,993 estimated to be in the United States. In order to fix the issue, dealers are being instructed to replace the relevant parts of the connector and harness. In a second, unrelated campaign, GM is also calling in 50,731 Chevy Spark and Sonic small cars – 45,785 of them in the US – due to a software glitch. In those affected vehicles fitted with the base radio and OnStar system, the audio system may not be able to switch out of turn-by-turn direction mode, causing the display to go blank and all sound to mute – including key safety warnings. In addition, the system may not switch off, draining the battery. GM states that no crashes, injuries, or fatalities have resulted from this issue, and all that dealers will need to do in this case is reflash the software. Related Video: General Motors is recalling 164,993 2006-2010 model year HUMMER H3 and 2009-2010 model year HUMMER H3T models in the U.S. In certain vehicles, the connector module that controls the blower motor speed in the heat/vent/air conditioning (HVAC) system may overheat under extended periods of operation at high- and medium-high speeds. The heat could melt the plastic surrounding the connector module, increasing the risk of a fire. Dealers will replace the affected portion of the connector and harness. GM is aware of three reported minor burns and 42 fires but no crashes or fatalities related to this condition. Including Canada, Mexico and exports, the total recall population is 196,379. ### General Motors is recalling 45,785 2014-2015 model year Chevrolet Sparks, and 2015 model year Chevrolet Sonics in the U.S.

GM to build outgoing Silverado and Sierra until late 2019

As it has done with previous generations, General Motors is keeping the outgoing versions of its 1500 pickups in production despite the arrival of the all-new 2019 Chevrolet Silverado and 2019 GMC Sierra. The production of the previous, K2 generation models will begin to be wound down gradually, according to Automotive News, starting with crew cabs "early next year," and double and regular cab models following during "the early second half of next year." The old model trucks will continue to be built into "late 2019" based on market demand, GM's spokesperson Kim Carpenter said. The Chevrolet will go by the name Silverado LD, with the GMC Sierra designation still to be announced. Some of the outgoing models are built by sharing the assembly work between two GM plants. Partially finished Silverado and Sierra double cab bodies are shipped from Fort Wayne, Ind., to Oshawa, Ont., where the trucks are completed, including receiving paint. This eases the workload in Fort Wayne, where production of the new T1 generation trucks started in July 2018. In January, the Silao plant in Mexico will take on the duties of building new generation regular cab and crew cab trucks. Carpenter also said that the "Oshawa shuttle," as the shared production is called, has been very successful. As a result, 60,000 more trucks will be built than what the original production forecast initially called for. GM's latest quarterly profits, disclosed last week to be $1 billion, have been far higher than expected and will result in full-year profits far higher than what had been predicted in light of steel tariffs. GM isn't the only truck maker taking a similar multi-generation approach for 2019. Both the outgoing and redesigned Ram 1500 are in production, with the previous generation being dubbed Ram 1500 Classic. Related Video: