1956 chevrolet restored Bel Air Gm Performance 350 on 2040-cars

Auto blog

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Recharge Wrap-up: Lexus CT 200h is NWAPA's favorite hybrid, 'No Charge to Charge' in LA

The Northwest Automotive Press Association (NWAPA) has given the Lexus CT 200h its Favorite Hybrid title. It named the compact luxury hybrid its favorite of 2014 at its Drive Revolution in Portland (where it also named the new Volkswagen Golf TDI the Northwest Green Car of the Year). According to NWAPA president Nik Miles, the CT 200h earned the honor for "impressive combination of state-of-the-art small car luxury and hybrid technology." For 2014, the Lexus CT200h got an updated front end, including the spindle grille we've been seeing on new Lexus vehicles, plus a redesigned steering wheel and sliding sun visors. Read more in the press release below. Chevrolet credits the Malibu for helping make stop-start mainstream. Chevrolet started including stop-start technology standard in Malibus equipped with the four-cylinder engine. Chevy has sold about 83,000 of that model, so 97 percent of 2014 and 2015 Malibu sales include stop-start. Now, that technology has made its way into the 2015 Impala. With drivers idling an average of 16 minutes a day, stop-start can significantly reduce harmful emissions and save fuel. According to Navigant Research, we can expect annual sales of cars equipped with stop-start technology to surpass 55 million by 2022. Read more in the press release below. Nissan Leaf customers in Los Angeles will get access to free charging beginning August 15. Nissan is extending its "No Charge to Charge" promotion to LA, which will allow customers to charge at public charging stations at no cost. Leaf customers - including those who bought or leased their car from the participating dealerships on or after July 1 - will get an EZ-Charge card, allowing them to use ChargePoint, Blink, CarCharging, AeroVironment and NRG eVgo chargers for free. Rapid chargers can charge the Leaf's battery to 80 percent in 30 minutes. Nissan plans to offer the "No Charge to Charge" in at least 14 more markets in the US, bringing the total to 25, within the next year. See the press release below for more details. California will get six all-electric school buses for three school districts as part of a demonstration program. The California Energy Commission awarded a grant of $1.4 million for the program to National Strategies LLC; this is in addition to a $2.2-million grant from the South Coast Air Quality Management District. The EV buses use vehicle-to-grid technology, allowing them to sell energy back to the grid when it is needed.