1956 Chevrolet Bel Air Coupe**4 Speed Manual** on 2040-cars

Auto blog

Cadillac Celestiq, Lyriq, Hummer, other future GM electric cars: Here's everything we saw at ‘EV Day’

WARREN, Mich. — Today, General Motors held an “EV Day” event at its Warren, Michigan, campus to present its new “Ultium” battery technology, modular electric vehicle architecture and soon-to-come electric vehicles. Unfortunately, we were forbidden from bringing cameras into the event, so while we canÂ’t show you what we saw, we can tell you more about it. While we saw the previously teased Cadillac EV (which we now know to be called the Lyriq) and the GMC Hummer pickup teased during the Super Bowl, there were a number of other future cars at the event, which GM President Mark Reuss assured us are all real vehicles in the works. The biggest surprise came at the end of the event, though, in the Cadillac Celestiq electric sedan, which Reuss described as a future flagship that would be hand-built “very locally.” It had been hiding under a dark sheet all morning, with the front and rear illuminated Cadillac emblems shining from underneath. When the wraps came off, we saw a long, white, four-seat fastback sedan. The 23-inch wheels were pushed out to the very corners of the car, giving it what appeared to be a very long wheelbase. The model on the stage had no side mirrors or visible door handles. The grille mirrored that of the Lyriq crossover next to it, with integrated lighting in lieu of the usual mesh or slats youÂ’d see in an internal combustion car. The entire roof, all the way until it tapered to the tail of the vehicle, was tinted glass. In back, vertical tail lighting ran down the C-pillar before turning rearward across the top of the trunk. Inside, everything below the beltline of the windows — essentially all but the headrests and top portion of the steering wheel, was hidden from view. Behind the Celestiq, a large digital display showed a rendering of its interior. The dash consists of a pillar-to-pillar curved LED display serving as both instrument panel and infotainment system. Protruding forward between the front seats was another touchscreen that appeared to house some more controls, with open area, probably for storage, below it. The rear seats had the same sort of touchscreen between them. Built into the back of the front seats were a pair of rear-seat entertainment screens, much like we saw in the Lyriq. The door panels blended wood, metal and animated lighting to give character and a sense of opulence. GM interior design manager Tristan Murphy was on hand to tell us a bit more about the Celestiq.

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

Surprise! GM putting aluminum in next-gen pickups

Last month, General Motors launched a series of ads touting the benefits of steel over aluminum – specifically, with regard to the Chevy Silverado versus the Ford F-150. (Kind of. We're not sure what a grizzly bear has to do with anything.) We took issue with the ads, with editor in chief Mike Austin saying they "reek of insecurity, and distract from the Silverado's strengths that could be used for positive advertising." But what bothers us more, is that yet another report surfaced claiming anti-aluminum GM will indeed use the weight-saving material in its next-generation fullsize trucks. On Tuesday, GM announced a $877-million investment for its truck plant in Flint, MI. But Reuters says that huge overhaul is because the trucks will use "substantially different equipment than the tools GM uses today." The report specifically states, "People familiar with the company's plans say GM's next-generation pickups and SUVs will make use of various materials, including aluminum and lightweight steel, to shed weight and gain fuel efficiency to meet tougher federal standards." The Silverado already uses a few aluminum components in the engine and hood, and if more widespread use will help GM build its best fullsize trucks ever, then that's great. Honestly, we have no reason to doubt that aluminum will be used in the next Silverado and GMC Sierra. We just hope GM remembers that nothing is ever truly deleted from the bowels of the Internet when it launches the subsequent "look how great aluminum is!" campaign. Related Video: News Source: Reuters Green Plants/Manufacturing Chevrolet GM GMC Truck aluminum steel