1956 Chevrolet Bel Air/150/210 Restomod on 2040-cars

Auto blog

Jaguar I-Pace vs. Tesla Model 3 and other EVs: How they compare on paper

The 200-mile club of electric vehicles is really growing. The most recent member is the Jaguar I-Pace, the company's first pure EV. It promises luxury, performance, style, and most important, good range. Nearly as recent is the Hyundai Kona EV, and while it doesn't promise luxury or performance like the Jaguar (it's also smaller), it does pack impressive range. With the introduction of both of these electric cars, we thought we would see how they compare against each other, and the other two big names in high-capacity electric cars: the Chevy Bolt EV and the Tesla Model 3. This isn't intended to be a direct, apples-to-apples comparison, as the four are quite different. If anything, they break into two groups: bigger and more luxurious, and smaller and less expensive. Then again, the number of vehicles with this electric range is small and comparisons to EV's with less range wouldn't be too kind to the other guys. If you want to learn more about these EVs, and compare them with other cars, be sure to check out our Car Finder and comparison tools. Horsepower and torque There is one clear winner here, and that's the Jaguar I-Pace. It packs a whopping 394 horsepower and 512 pound-feet of torque. That comes through a pair of electric motors (one at the front, another at the rear) that provide the Jag with all-wheel drive, the only one of these vehicles to offer it (at the moment). Altogether, it allows the I-Pace to have the best 0-60 mph time of 4.5 seconds. At the other end of the spectrum is the Hyundai Kona EV. It's front-drive, like the Bolt EV, and has effectively the same amount of horsepower as the Chevy at 201 horsepower, but its 0-60-mph time is almost a second slower. And the low-range version of the Kona, excluded because it doesn't go more than 200 miles between charges, is slower still. The Tesla Model 3 is the only vehicle with rear-wheel drive, and with a 0-60 mph of 5.1 seconds for the Long Range model, it is still very quick. Range and energy use Frequently, the all-consuming question with electric cars is, "How far can I go on a charge?" And to go the farthest, you need the long-range Tesla Model 3. It can go 310 miles. It has the added advantage of being able to use the network of Tesla Supercharger stations, though they are pay-per-use with the Model 3. Even the lower capacity Model 3, with just 220 miles of range, can use these stations.

Chevy's 6.6-liter Duramax is pretty much all new

To say there's a heated battle in heavy-duty pickups is an understatement, with Chevrolet, Ford, and Ram constantly trading blows of increased torque, horsepower, and towing capacity. The latest salvo is the revised, more powerful turbo diesel 6.6-liter Duramax V8 in the 2017 Chevy Silverado. It has 910 pound-feet of torque, an increase of 145, putting it nearly level with the Ford Super Duty. Here's a closer look at where those gains come from. How exactly did Chevrolet add all that torque plus 48 horsepower? The automaker essentially took a fine-tooth comb to the entire engine. Chevy says it changed 90 percent of the V8, and the cumulative effect of those small changes adds up to big increases. As you might guess, the turbocharger is updated. The larger unit features electric actuation of the variable nozzle turbine (VNT), and what Chevy calls a double axle cartridge mechanism that separates the VNT moving parts from the housing. That helps with heat performance as well, with a claim that the exhaust side of the turbo can run continuously up to 1,436 degrees Fahrenheit. Helping that cause are six exhaust gaskets made of Inconel - an nickel alloy that contains chromium and iron – and upgraded stainless steel for the exhaust manifold. Despite having the same cast iron cylinder block, albeit with some minor enhancements, the engine has new cylinder heads, pistons, piston pins, connecting rods, and crankshaft, which have all been upgraded to handle 20 percent higher cylinder pressures. Alongside the increase in pressure, Chevrolet also increased the cylinder head's structure with a honeycomb design. The pattern features high-strength aluminum with dual layer water jackets that not only improve strength, but also optimize water flow for better cooling. For 2017, the cylinder head also benefits from integrated plenum that aids the engine in getting more air under heavy loads. The cylinder head isn't the only component to get a minor update, as the pistons have a larger diameter pin for improved oil flow. The same detailed improvements has been bestowed to the humble connecting rods (second in our hearts only to the inanimate carbon rod). The new design has the bolts oriented roughly 45-degrees to the rod instead of parallel. The angle split design, as it's called allows for easier passage through the cylinder.

Final C6 Corvette built in Bowling Green

With all of the attention given to the 2014 Chevrolet Corvette Stingray lately, you could be forgiven for thinking that it's already well along in production, yet tooling up for the new C7 has only just begun. In fact, production of the outgoing C6 generation in Bowling Green, Kentucky just halted on Thursday.
As the C6 has aged, production numbers have predictably ebbed along with demand, but this year, the addition of the 427 and 60th anniversary models resulted in an uptick in vehicles built - this, despite a model year shortened by around 25 percent to accomodate the new model changeover. The final C6 Corvette ever, No. 13,466 built this year, was a white 427 Convertible destined for the General Motors Heritage Center museum. The car's 7.0-liter V8 heart was assembled by Corvette chief engineer Tadge Juechter himself.
In total, Bowling Green pushed out 215,100 C6 Corvettes over nine years. If you're still a C6 fan at heart and are hoping to get a good deal on a phase-out model, step lively - Chevrolet reportedly had about 6,100 unsold units, which Autoweek suggests is good for around five and a half months of supply at the model's current sales rates. Given that demand will likely slacken even further as the C7 draws closer, that should be a big enough stockpile to keep dealers satisfied until 2014 Stingrays begin showing up on their forecourts in December.